315797
6
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
6
Never pull the charger lead to
disconnect the charger from
the socket. Keep the charger
lead away from heat, oil and
sharp edges.
After use
Unplug the charger before
cleaning the charger or
charging base.
When not in use, the
appliance should be stored in
a dry place. Children should
not have access to stored
appliances.
Inspection and repairs
Before use, check the
appliance for damaged or
defective parts. Check for
breakage of parts, damage to
switches and any other
conditions that may affect its
operation.
Do not use the appliance if
any part is damaged or
defective.
Have any damaged or
defective parts repaired or
replaced by an authorised
repair agent.
Regularly check the charger
lead for damage. Replace the
charger if the lead is
damaged or defective.
Never attempt to remove or
replace any parts other than
those specified in this manual.
Battery
Never attempt to open the
battery for any reason.
Do not expose the battery to
water.
Do not incinerate the battery.
When disposing of batteries,
follow the instructions given
in the section “Protecting the
Environment”.
Charger
Do not expose the charger to
water.
Do not open the charger.
ELECTRICAL SAFETY
Your charger has been designed
for a specific mains voltage.
Always check that the mains
voltage corresponds to the
voltage on the rating plate.
Your charger is double
insulated in accordance with
EN 60335; therefore no
earth wire is required.
Never attempt to replace
the charger unit with a
regular mains plug.
INSTALLATION
Fitting the charging base to the
wall (fig. B)
The charging base can be fitted
to the wall to provide a
convenient storage and charging
point for the appliance.
Find a suitable indoor
location near a mains outlet.
Position the charging base as
shown and mark the location
of the mounting holes (6) on
the wall.
Drill a hole (ø 6 mm, approx.
35 mm deep) at each of the
marked locations.
Insert the wall plugs (7)
provided into the holes.
Fit the charging base to the
wall using the screws (8)
provided. Make sure to guide
the charger lead through the
slot (9). Excess lead can be
stored at the rear of the
charging base.
ENGLISH
Dustbuster_UK_A5_A6.PM5 01-05-2001, 11:086
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

black-decker-v-2400-dustbuster

Suche zurücksetzen

  • Ich müsste den Akku ersetzen. Wie kann ich das machen? Eingereicht am 1-6-2019 09:55

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Black Decker v 2400 dustbuster wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info