Bedienungsanleitung Blaupunkt RATK 750104 (Seite 17 von 20) (Deutsch, Englisch)

716237

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Operating the trimmer

1． To switch on the trimmer ﬁrst press the On/Oﬀ trigger. To switch oﬀ simply release the On/Oﬀ switch trigger.

2. The lawn trimmer comes with a full spool of line. The line wears down during work. To ensure that the line is always the optimal

length a small amount of line is released by the spool each time you operate the machine. To release more line gently pull on

the line and press the square button on the side of the spool several times. The trimmer line will be cut to the right length by

the blade on the line cover.

3. Do not overload the trimmer, cut in small sections which will greatly improve eﬃciency by keeping the trimmer running at high

speed,

4. For the correct cutting action, swing the line trimmer from side to side as you walk forward, holding it at an angle of approx. 20°

as you do so.

5. Make several passes to cut long grass shorter step by step from the top. (Fig. H)

6. Keep the line trimmer away from hard objects in order to avoid unnecessary line wear.

7. Use the edge of the guard as a guide when cutting near fences and walls, etc. Moving trimmer in a backwards direction will

avoid damage (Fig. I)

MAINTENANCE AND CLEANING

Warning: Switch oﬀ and disconnect from mains supply before replacing, adjusting or cleaning your trimmer. Be aware that

the trimmer continues to rotate for a few more seconds after it has been switched oﬀ.

To Store: Store it out of the reach of children, in a stable and safe position and in a dry place where the temperature is not too hot

or too cold.

• Store the trimmer away from direct sunlight, if possible in a dark or barely lit place.

• Do not store in a nylon bag as this could encourage the formation of damp patches.

• Do not store the grass trimmer resting on the ﬂoor. Hang it by the upper handgrip instead, so that the guard does not touch

anything. Ensure the resting guard does not touch anything. The resting of the guard on a surface could alter its shape and

therefore its dimensions and safety characteristics would be modiﬁed.

To Clean

• Regular cleaning and maintenance of you grass trimmer will ensure eﬃciency and prolong the life of your machine.

• After each cutting operation, take apart and clean out the grass and soil from; the spool and its slot, the whole trimmer and

in particular the guard.

• During operation, keep the air vents clean and free of grass.

• Only use a cloth soaked with hot water and a soft brush to clean it.

• Do not spray or wet the appliance with water.

• Do not use detergents or solvents as these could ruin the trimmer. The parts in plastic can easily be damaged by chemical

agents.

• If the wire cutting blade no longer cuts or breaks, have this replaced by contacting an authorised service center.

• Take special care to clean around the inside of cutting head guard, the cap and motor housing cooling vents.

• Refer to qualiﬁed service personnel if internal maintenance is required.

• CAUTION! The blade can give deep cuts.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Blaupunkt RATK 750104 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info