Bedienungsanleitung Blaupunkt RXplus45e (Seite 45 von 51) (Deutsch, Englisch)

647266

Zoom out

Zoom in

Vorherige Seite

1/51

Nächste Seite

RX+45e

FM mode

Briefly press the ‘Standby’ button on the top of your radio to go to FM mode.

When your radio is in FM mode it can receive Radio Data System or ‘RDS’ information if this

is being transmitted by the broadcaster. RDS information will often include the station

name, detail about the programme and the current time.

If you were listening to an FM station when you switched the radio off then this station

will be automatically selected when you switch the radio back on.

Telescopic aerial

Please make sure that the aerial on the back of the radio is fully extended and adjusted

before you attempt to tune to an FM station (a vertical position is recommended). This will

ensure that the maximum signal strength is available when the radio begins to scan.

Extending the aerial also ensures the best possible sound quality.

Tuning to an FM station

1. Press and release the ‘Scan’ button on the top of your radio to scan up the frequency

band. Press and hold ‘Scan’ to scan down the frequency band. Your radio will search for the

next available station and then stop on that station.

2. Use the right hand rotary tune control to fine tune each frequency in 0.05MHz steps.

You can also turn the rotary tune control quickly to go straight to a specific frequency.

The RDS information for each station will be displayed, if available.

Note: If reception is still poor adjust the position of the aerial or try moving the radio to

another location.

Storing an FM station preset

Your radio can store up to 10 FM stations in its preset memories for instant access to your

favourite stations.

Note: When you store FM radio station presets, these do not overwrite your DAB station

presets.

1. Tune your radio to the station that you wish to preset (see Tuning to an FM station on

this page).

2. Press and hold the preset button on the top of your radio that you would like to store

the station to (1-5) for 3 seconds. ‘Preset X stored’, where ‘X’ is the number of the preset

location will be displayed.

3. To store a preset under preset locations 6-10, press and release ‘Shift’, ‘<Preset 6 - 10>’ is

displayed, then press and hold the preset button that you would like to store the station

to for 3 seconds.

Note: If there is already an existing FM station stored under a preset, it will be over written

when you store the new station.

Tune to an FM preset station

In FM mode:

1. For presets 1-5, simply press the Preset location button and your radio will tune to the

station stored under that button.

2. For presets 6-10, press and release the ‘Shift’ button, then press the preset location

button. Your radio will then tune to the station stored under that button.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Blaupunkt RXplus45e Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Blaupunkt RXplus45e

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info