165764
27
Zoom out
Zoom in
Vorherige Seite
1/33
Nächste Seite
27
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Setting the equaliser
The acoustic characteristics of the car in-
terior affect the quality of the sound repro-
duced in your vehicle to a much greater ex-
tent than the speakers.
Position, installation and the rear volumes
of, for example, the door or rear window
shelf all play an important role.
Even the sound produced by well selected
and installed speakers can be affected ne-
gatively by resonance frequencies in the
vehicle interior.
As a result, the bass sounds may be lost or
reverberate, the mid-range tones sound too
overpowering and music instruments or
voices may be distorted or the total sound
quality may be completely lifeless.
The overall sound quality can be greatly
enhanced if certain frequencies are suppres-
sed or boosted.
This car radio has been equipped with a
parametric filter. The “LOW EQ” filter can
be set from 32 to 500 Hz. In this context,
parametric means that it is possible to set
the frequency for the filter and either boost
or reduce it (+10 to -20 dB) individually.
This parametric filter can be adjusted to very
exact settings even without the help of
measuring instruments.
The individual steps required to make the-
se settings are described in the table.
Notes on making the settings
The following notes are intended as recom-
mendations only. They do not necessarily
reflect your own personal sound prefe-
rences.
We recommend that you use a music CD
you are familiar with to make the settings.
The CD should include tracks with different
instruments and vocals. Purely electronic
music is not well suited to serve as a basis
for making the settings because the original
sounds cannot be determined.
Before you set the equaliser, set bass, treb-
le, balance and fader to “0”.
This setting is described in the Quick Refe-
rence under A AUD.
Now listen to the CD you have selected.
Evaluate the sound according to your own
personal preferences.
Now refer to “Sound impression/problem” in
the table and you will find suggestions to
eliminate any problems under “What to do”.
Make the settings for bass and the lower
mid-range tones with the LOW EQ filter.
The “LOW EQ” filters can be set in the DSC
menu:
Press DSC.
Press
/ as often as necessary until
“LOW EQ” appears in the display.
Press << or >> once and
Set the level in the following table by
pressing
/ .
Press << >> to switch the frequency
range.
Press
to store your settings.
You can switch the equaliser on and off by
pressing AUD for approx. 2 seconds.
Now you can compare the sound produced
by your car radio with and without the equa-
liser.
27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Blaupunkt viking tmc 148 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Blaupunkt viking tmc 148

Blaupunkt viking tmc 148 Bedienungsanleitung - Deutsch - 32 seiten

Blaupunkt viking tmc 148 Installationsanweisung - Alle Sprachen - 21 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info