698739
7
Zoom out
Zoom in
Vorherige Seite
1/92
Nächste Seite
5
1. Lid with feeder
2. Vertical screw
3. Extrusion bowl
3a. Filter guides
3b. Switch for closing the juice flow
4. Juice filters (thick, fine filter)
5. Horizontal worm
6. Blocking element with the pulp outlet
7. Juice cup
8. Container for pulp
9. Pusher
10. Body
BEFORE FIRST USE
1. Remove all papers, cartons, foil which secure the juicer and juicer parts.
2. Clean the juicer following the advice in Cleaning and Maintenance chapter.
3. It is recommended to assemble and disassemble the juicer before using.
ASSEMBLING THE DEVICE
1. Place the bowl (3) onto the body of the unit (10), and make sure that the three tabs fit into the
holes in the bowl.
2. Insert the selected filter (4) into the guides (3a).
3. Place the horizontal worm (5) in the extrusion bowl so that it fits into the drive.
4. Insert the locking element (6) into the extrusion bowl, taking note of the printed symbols, and
turn clockwise to the closed position.
5. Insert the vertical screw (2) on the top.
6. Place the cover onto the bowl, paying attention to the symbols.
FOOD PREPARATION
Remove stones (plums, peaches, cherries etc).
Remove tough skins (melons, pineapples, cucumbers, potatoes etc).
Soft-skinned and other foods just need washing.
Cut the food into smaller pieces to fit the feed tube.
USING THE DEVICE
To start the juicer, press and hold the On/Off button for 3 seconds. The key lock will be disabled.
Start the juicer with the On/Off button for normal mode, or use the Soft button for pressing soft fruit.
Place fruit or vegetables in the feeder, and slowly push through by pressing the pusher.
Use the "reverse" function only when the screw conveyor is blocked or clearly slows down.
Do not switch the direction of the rotation until the unit has come to a complete stop.
Some very hard foods may make your juicer slow down or stop. If this happens switch off and unblock
the filter.
Insert soft food slowly to get the most juice.
Some fruits and vegetables may block filter during work which cause decrease of the juicing efficiency.
If you observe that during work, efficiency is getting to low, cleaning of filter is needed.
CLEANING AND MAINTENANCE
Warning: The juicer has a rinse-during-operation function, activated between the pressing of various
fruits or vegetables. Close the juice flow (3b), pour some water into the feeder (approx. 0.1-0.2l), and
start the cleaning mode by pressing the "Clean" button. The juicer will perform 6 rotation cycles and
switch off. Open the juice flow.
For easy cleaning - immediately after each use rinse removable parts under running water (to remove
wet pulp). Allow parts to dry.
After disassembling the unit all removable parts may be washed in hot soapy water.
The lid, bowl, pulp container, juice cup are dishwasher safe.
SJV701
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Blaupunkt SJV701 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info