63
Malfunction
Appliance does not work.
The food is too warm.
Appliance cools too much.
Possible Cause
Appliance is not switched on.
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Mains malfunctions are to be corrected by an
electrician.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Turn the temperature regulator to a warmer
setting temporarily.
Temperature is not properly adjusted.
Please look in the "Initial Start Up" section.
Door was open for an extended peri-
od.
Open the door only as long as necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature regulator to a colder set-
ting temporarily.
The appliance is near a heat source.
Please look in the "Installation location"section.
Light bulb is defective.
Please look in the "Changing the Light Bulb”.
Interior lighting does not work.
Unusual noises.
Appliance is not level.
The appliance is touching the wall or
other objects.
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the appliance or the wall.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component out
of the way.
Carefully warm the leaking sections of the door
seal with a hair dryer (not hotter than approx.
50 °C).
At the same time shape the warmed door seal
by hand such that it sits correctly.
Door seal is not air tight (possibly
after changing over the hinges).
Heavy build up of frost, possibly also
on the door seal.
The compressor does not start imme-
diately after changing the tempera-
ture setting.
This is normal, no error has occurred. The compressor starts after a period of time.
Water drain hole is blocked. See the "Cleaning and Care" section.
Water on the floor or on storage
shelves.
