Bedienungsanleitung Blomberg TKF 8451 AG60 (Seite 4 von 56) (Deutsch, Englisch)

581569

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

break off during drying.

• Never attempt to repair the product

yourself. Do not perform any

repair or replacement procedures

on the product even if you know

or have the ability to perform the

required procedure unless it is

clearly suggested in the operating

instructions or the published service

manual. Otherwise, you will be

putting your life and others' lives in

danger.

• For failures that you cannot remedy

by applying the procedures in safety

instructions, turn off and unplug

the product and call the Authorized

Service Agent.

• Do not reach into the machine when

the drum is spinning.

• Do not use extension cords, multi-

plugs or adaptors to connect the

dryer to power supply in order to

decrease the risk of fire and electric

shock.

• Never wash the product by spreading

or pouring water onto it! There is the

risk of electric shock!

The final step of the drying

programme, namely the cool-down

step is performed without applying

heat to ensure that the laundry items

are kept at a temperature that will

not damage them. If you open the

loading door before the cool-down

step completes, hot vapour will come

out.

Never stop the dryer before the

programme completes. If you must

do this, remove all laundry quickly

and lay them out to a suitable place

to dissipate the heat.

• Always clean the lint filter before or

after each loading. Never operate the

dryer without the lint filter installed.

• Clean inside and exhaust duct of the

product regularly. Do not allow fibre,

dust and dirt accumulation around

the exhaust exit and at adjacent

areas.

• Power cable plug must be within easy

reach after installation.

• Do not dry unwashed items in the

dryer.

• Items soiled with cooking oils,

acetone, alcohol, fuel oil, kerosene,

stain removers, turpentine, paraffin

and paraffin removers must be

washed in hot water with plenty of

detergent before being dried in the

dryer.

• Garments or pillows bolstered with

rubber foam (latex foam), shower

bonnets, water resistant textiles,

materials with rubber reinforcement

and rubber foam pads should not be

dried in the dryer.

• Do not use fabric softeners and

anti-static products unless they are

recommended by the manufacturers

of the relevant product.

• Use softeners, anti-static products

and etc. in accordance with the

instructions of their manufacturers.

• Do not install the product behind a

door with a lock, sliding door or a

hinged door which can strike the

product.

• Do not install or leave the dryer in

places where it will be exposed to

outdoor conditions.

• Your product can be operated at

temperatures between +5°C and

+35°C. If the operating conditions fall

outside of this range, operation of the

product will be adversely affected and

it can get damaged.

• Do not tamper with the controls.

• Unplug the product when it is not in

use.

• Remove the loading door of

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Blomberg TKF 8451 AG60 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info