Bedienungsanleitung Blue Air Sense plus (Seite 4 von 9) (Englisch)

807187

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

Get the most out of it

Maximum speed is recommended for fast initial cleaning or for heavily polluted air. After a few minutes,

the speed can be reduced. Minimum speed is generally recommended for nighttime use.

For best results, run Sense+ 24/7. This ensures that clean, ﬁltered air constantly circulates throughout

the room. Sense+ uses as little as 7 W, less than a low-energy light bulb.

Start it

Plug Sense+ into a grounded electrical outlet with the supplied power cord. To turn it on for the ﬁrst

time, sweep your hand over the top display. A blue LED on the front side indicates that the unit is

working.

Place it

Sense+ should be placed in a location that allows air to circulate freely in, out and around the unit.

Minimum distance from another object is 10 cm.

Don’t place the unit:

Directly on or against soft furnishings, such as bedding or curtains.

Near sources of heat, such as radiators, ﬁreplaces or ovens.

Near wet areas, such as bathrooms or laundry rooms, where it may come into contact with water.

Outdoors.

Warning: Changes or modiﬁcations to this unit not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

FCC ID: 2AEX3-Sense+

IC ID: 20267-Sense+

However, there is no guarantee that interference will not occur in a particular installation. If this equip-

ment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject

to the following two conditions: (1) this device may not cause interference, and (2) this device must

accept any interference, including interference that may cause undesired operation of the device.

This Class B digital apparatus complies with Canadian ICES-003.

FCC RF Radiation Exposure Statement Caution: This Transmitter must be installed to provide a

separation distance of at least 20 cm from all persons.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Blue Air Sense plus Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info