651934
34
Zoom out
Zoom in
Vorherige Seite
1/58
Nächste Seite
34
BS 1714 A CB_IM_new 23.06.16
Assembly and Battery Charging
Installing the Charging Station on a Wall
WARNING:
Make sure beforehand whether there are cables in the wall
which could be damaged!
NOTE:
A power outlet must be near.
Assemble the wall holder without the base.
1. Hold the wall holder against the wall and mark the 3
holes.
2. Drill the holes and insert the dowels into the wall.
3. Screw the screws into the dowels and suspend the wall
holder.
4. Tighten the screws by hand.
Assembly of the Appliance
Refer to the illustrations on page 4.
A If you do not want to fasten the charging station to a wall,
set the wall holder onto the base. It must engages. Set
the assembled charging station onto a level, solid surface.
B Connect the power cable to the connection socket on the
charging station.
C Connect the appliance holder with the oor nozzle. It
must engages. Take note of the contact pins on the oor
nozzle.
D Fix the basic unit in the appliance holder.
CAUTION:
The telescopic crevice nozzle must be pushed in! If the
basic unit is set into the appliance holder with extended
crevice nozzle, the crevice nozzle will jam.
First, insert the crevice nozzle into the opening of the
appliance holder. Then push the handle of the basic unit
into the appliance holder. It must audibly engage.
E When you want to charge the battery, hang the complete-
ly assembled appliance into the charging station. Make
sure of stability and correct assembly. The contacts of the
appliance holder must touch the contacts on the charging
station. The 4 contacts must be clean and dry. Otherwise
the battery will not be charged.
F For space-saving storage, you can fold the handle of the
appliance holder. To do this, press the button (13).
Charging the Battery
1. Turn off the device (Position of both switches: O).
2. Connect the mains adapter to a certied wall socket.
Charge the device for 12 - 14 hours before rst-time use.
NOTE:
The pilot lamp ashes during charging.
The pilot lamp is lit continuously when the battery
has been charged completely.
It is normal for the device to heat up during charging.
3. Stop any charging operation after a maximum of
12 hours.
CAUTION:
Always disconnect the plug from the wall socket after
12 hours of charging.
NOTE on battery life:
Observe the following in order to prolong battery life:
Charge the battery only when it is almost empty.
Charge the device at an ambient temperature between
0 ° and + 40 °C.
Using the Device
You can use the appliance as a oor vacuum cleaner or as
a handheld and upright vacuum cleaner (basic unit).
To separate the basic unit from the appliance holder, press
the button (12) and at the same time use the handle to pull
out the appliance. (Page 5, Fig. G)
Turn the appliance on or off with the on / off switch (3) or (15).
NOTE:
When you use the appliance as a oor vacuum cleaner, it
can be turned on also with the on / off switch on the basic
unit. In this case, it can be turned off only with the switch on
the basic unit.
Telescopic Crevice Nozzle on the Basic Unit
You can extend the crevice nozzle.
Pull out the crevice nozzle until the lock (23) on the rear of
the appliance engages.
To retract the crevice nozzle again, press the unlock
button (23).
Emptying the Collection Container
Refer to g. K on page 5.
1. Turn off the device (Position of both switches: O).
2. Keep the device horizontal when opening the collection
container.
3. Slide the unlock button (24) and at the same time turn the
motor housing off the catch tray.
4. Pull rst the ne dust lter and then the coarse dust lter
from the catch tray.
5. Empty the components.
6. Reinstall the components into the collection container in
reverse order.
7. Proceed as follows to reattach the catch tray to the motor
housing:
Conrm the 3 projections on the motor housing and the
3 recesses on the catch tray. Set the projections into the
recesses and at the same time tighten the motor housing.
The lock (24) must engage.
34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bomann BS 1714 A CB wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info