Bedienungsanleitung Bomann BS 1949 (Seite 42 von 74) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

687988

Zoom out

Zoom in

Vorherige Seite

1/74

Nächste Seite

BS1949ACB_IM 20.10.16

CAUTION:

• The ambient temperature should be between 0 °C and max. 45 °C.

Heat damages the rechargeable battery. Increasingly lower tem-

peratures reduce the capacity and the life of the rechargeable

battery.

• Do not charge the rechargeable battery unsupervised.

• Use only the mains adapter “ZD12D265050EU” included in the

scope of deliveries.

• Disconnect the power supply unit from the mains when you will

not use the device for a longer time.

Overview of the Components / Delivery Scope

1 Button for unlocking / locking the  lter unit

2 LED charge indication

3 Multifunction button / + / –

4 Carrying handle

5 Socket for connection of the power supply unit

6 Dust collector base plate

7 Dust collector with HEPA  lter

8 Lock of the dust collector

9 Opener of the dust collector

10 Suction tube

11 Unlocking the  oor nozzle

12 Button for unlocking the brush roller

13 Floor nozzle with turbo brush

14 Unlocking for suction pipe or nozzle attachment

15 Adapter for the nozzle attachment

16 Combined crevice / brush nozzle

17 Upholstery brush

18 Wall holder

Not shown:

1 x Mains adapter

2 x Wall plug

2 x Screw

Unpacking the Device

1. Remove the device from its packaging.

2. Check the delivery scope for completeness.

3. Check the device for any transport damage, in order to

prevent hazards.

NOTE:

In case of any transport damage, contact your dealer

immediately. Do not use a damaged device!

4. Remove the transport lock from the multifunction button.

Notes on Use

• The device is especially suitable for quickly vacuuming

small amounts of dry dirt or dust.

• The device is operated via charged battery. Charging is

done via the supplied power supply unit.

• Direct power supply via mains adapter is not possible.

Multifunction Button (

/ + / –)

Use the multifunction button to turn the device on and off.

Also select a power level with this button.

Press once = Turn on the device, low power level

Press twice = Select high power level

Press three times = Turn off the device

Start-up

Suction Tube

• Insert the suction pipe with the two contact pins into the

connection on the hand unit. It must audibly engage.

• To disconnect the suction pipe, press the release (14) and

pull out the pipe at the same time.

Floor Nozzle with Turbo Brush

The  oor nozzle is suitable for any  oor covering. During

operation, the LEDs on the  oor nozzle light up for better

visibility in dark areas.

CAUTION:

You cannot replace the LEDs.

• Slip the lower end of the suction pipe onto the connector

on the  oor nozzle. Pay attention to the contact pin. The

suction pipe must audibly engage.

• To release the suction pipe, push the release (11) away

from the suction pipe and pull out the pipe at the same

time.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann BS 1949 Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info