Bedienungsanleitung Bomann bs 974 cb (Seite 26 von 42) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Norwegisch)

320248

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

ENGLISH

Nozzle Attachment

Crevice and

jointed nozzle:

For vacuuming upholstery, curtains and

in corners and crevices etc.

„2-in-1“ nozzle: When they are joined

together you can use them as a brush

nozzle. If you would like to use the

crevice nozzle, pull the brush section off.

Floor nozzle: To clean carpets or smooth surfaces.

Releasing the

nozzles:

Pull these off while turning slightly.

Air Slide (1)

Open the air slide on the hose handle in order to regulate the

airﬂ ow or to clear any particles sticking to the nozzle.

Dust bag replacement display (6)

Hold the hose up into air. If the display is red the bag is full.

Please replace it.

Changing the dust bag

• Pull the plug out of the socket.

• Open the lid of the dust bag compartment by the handle (7)

(the cover must click into place).

• Remove the bag by carefully pulling the clamp towards

the front so that the bag becomes more accessible. Then

remove the dust bag by pulling it upwards.

• Insert a new bag. Please ensure that the bag is located

correctly in the guide mechanism. Then reinsert the retainer.

Close the cover so that it snaps into place.

Filter

Your appliance has two ﬁ lters.

Motor protection ﬁ lter (inlet ﬁ lter)

The inlet ﬁ lter is located in the dust bag compartment. The ﬁ lter

is located vertically in the rear section of the dust housing.

• Remove the grille by pulling it upwards and then take out the

motor protection ﬁ lter.

• Clean the engine protection ﬁ lter after 10 dust bag changes.

If necessary, the ﬁ lter can also be washed in warm water

without any additives.

• Place it back into place only once it is completely dry!

• Please push the grille back down into the guide mechanism

until it locks into place.

Outlet ﬁ lter

The appliance is also equipped with an outlet ﬁ lter. This ﬁ lter is

to be found under the ﬁ lter cover (8).

• Press the lever above the ventila-

tion grille downwards in order to

open it.

• Then pull the grille out towards the

front.

• Remove the ﬁ lter and clean as

described above.

• Please re-insert the ﬁ lter correctly

and close the ventilation grille

(until it clicks in place).

Cleaning and storage

Cleaning

• Pull the plug out of the socket before cleaning!

• Clean the casing with a dry cloth.

Storage

• Let the iron cool down completely.

• Wind the cable completely.

• If you position the device horizontally: Please insert the hook

of the ﬂ oor nozzle into the parking assistant on the rear of

the device.

Troubleshooting

• The Device Does Not Work.

Remedy:

Check the connection to the mains.

Check the position of the switch.

• The device does not suck up anything.

Possible Cause:

The dust bag is full.

Remedy:

Renew the dust bag.

Possible Cause:

The ﬁ lters are dirty.

Remedy:

Clean the components.

Possible Cause:

There is a foreign body in the suction tube or the nozzle.

Remedy:

Check the accessories for foreign bodies.

05-BS 974 CB 26 29.03.2007, 15:06:23 Uhr

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann bs 974 cb Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info