Bedienungsanleitung Bomann BSS 6000 CB (Seite 44 von 78) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

814746

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

BSS6000CB 17.10.17

Installation

Before you are able to use the appliance you have to assem-

ble it rst. Proceed as follows:

Rollers

1. Plug the black feet left and right on the bottom next to

the outlet opening of the appliance. Secure each with a

screw.

2. Plug the rollers into the bottom of the foot.

Shampoo Tank Bracket

Insert the shampoo tank bracket opposite of the rollers al-

ready mounted. Secure it on both sides each with a screw.

Wheels

Attach the big wheels left and right at the shampoo tank

bracket.

NOTE:

Once the wheels are mounted, it is no longer possible to

detach them!

Carrying Handle

Install the handle with 2 screws onto the engine housing.

Connecting and Detaching the Hose

Suction Function

• Put the hose connection into the suction opening on the

collection vessel. Use the guides to do so.

• Turn the hose connection towards . In order to

remove the suction hose twist off the hose connection

counterclockwise.

Blower Function

• Insert the hose connection into the blower opening at the

engine housing. Use the guides to do so.

• Turn the hose connection towards . In order to remove

the suction hose twist off the hose connection clockwise.

2-part Suction Pipe

• Insert one of the suction pipes with the thicker end into

the hose end.

• Insert the other suction pipe with the thicker end onto the

rst suction pipe.

• To release the suction pipes, pull them off while turning

them slightly.

Notes on Use

Protective Filter Made of Foam

Beneath the motor, there is a protective lter made of foam.

This is required for both wet and dry vacuuming.

• If not yet in place, put the protective lter over the suction

basket.

NOTE:

• The protective lter must fully enclose the suction

basket.

• You should check the condition of the lter and that it is

rmly in place at regular intervals.

Permanent Filter (Only when Vacuuming Dry)

Put the permanent lter over the protective lter.

NOTE:

The permanent lter must fully enclose the suction basket.

Attaching the Motor Housing

• Adjust the motor housing so that the on / off switch (I / O / II)

sits above the suction opening.

• Close both locking mechanisms.

Nozzle Attachment

Wet / Dry Brush

You may vacuum leaked or spilled liquids of at surfaces,

carpets and parquet with the wet / dry brush.

NOTE:

Check the maximum ll capacity of the collection vessel.

10 litres of liquid without foaming additive!

Shampoo Brush

You may clean carpets with a commercial carpet shampoo by

using the shampoo brush.

Upholstery Brush

You may clean upholstery with a commercial upholstery

shampoo by using the upholstery brush.

Crevice Nozzle

For vacuuming upholstery, curtains and in corners and

crevices etc.

Mains Lead

• Completely unwind the cable during operation.

• After use, allow the motor housing to cool down. You may

wind the cord around the engine housing afterwards.

Turning On / Off

The On / Off switch has several functions:

0 Off

I Wet and dry vacuuming / Blower function

II Vacuuming with shampoo

NOTE:

Switch position II additionally activates the pump.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann BSS 6000 CB Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info