Start-up
1. Insert the vacuum hose in the opening in the dust bag compartment until it
locks in mechanically.
2. In order to release the hose again press the two clamps on the connection
head inwards. Keep the clamps pressed and then pull the hose out.
3. Insert the vacuum tube on the handle piece.
Using the Appliance
1. Install the accessory.
2. Unwind the necessary length of cable and insert the plug in a duly installed
230V/50Hz protective contact socket.
3. Set the vacuum power with the vacuum power regulator.
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator
Low vacuum power: For curtains and delicate fabrics
Medium vacuum power: For long-pile velour carpets and textile flooring
High vacuum power: For sturdy rugs and floors
Cable winding device
Pull out the cable up to the maximum length indicated with the yellow mark. Never
pull the cable out up to the red mark as the cable winding can be damaged. Said
damages are not covered by the warranty.
Winding
Press the cable winding button and guide the cable. Hold the cable to avoid wrapping.
Nozzle accessories
1. If you wish to use the nozzle attachments, pull the flap on the upper section of
the housing.
2. Remove the desired nozzle:
Crevice nozzle/Brush nozzle: To vacuum corners and slits
"2-in-1" nozzle: When this is folded together (as sto-
red in the compartment) it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull
the brush section in the direction of the arrow until it
locks in place.
Upholstery nozzle: To clean upholstery, curtains, etc.
34
GB
4....-05-CB 948 13.03.2002 10:51 Uhr Seite 34
