Bedienungsanleitung Bomann DBS 783 CB (Seite 39 von 74) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

651922

Zoom out

Zoom in

Vorherige Seite

1/74

Nächste Seite

Intended Use

This appliance is intended for ironing of clothing and textiles.

It is intended for use in households.

Any other use shall be considered as not intended use and can

lead to material damage or even personal injury.

Overview of the Components

1 Steam jet button

2 Connecting tube

3 Mains lead

4 Base

5 Iron rest

6 Releasing device for handle “UNLOCK”

7 Water tank with lime lter

8 Handle

9 Lock for continuous steam

10 Steam jet button

11 Selector button SET

12 Control lamp

13 Temperature selection display

14 Lime lter cartridge

not shown

RELEASE button below the water tank. Releasing device of the

water tank

Instructions

Unpacking

• Remove any protective foils and stickers from the soleplate.

• Please unwind the lead completely.

Electrical connection

• Make sure that the iron voltage (see name plate) and the

line voltage match.

• The mains plug should only be inserted into a correctly

installed socket with earthing contact.

Power Requirements

The station has a total maximum wattage of 2400 W. With this

connected load a separate supply line protected by a 16 A

household circuit breaker is recommended.

CAUTION: Overload!

• If you use extension leads, these should have a cable

cross-section of at least 1.5 mm²

• Do not use any multiple sockets, as this device is too

powerful.

Turn on and off

Turn on: Connect the mains plug to a properly installed

safety socket. The appliance is immediately

switched to operating mode. This is indicated

by the red control lamp in the display.

Turn off: Press the selector button SET (11) repeat-

edly until the red control lamp appears in the

display. Disconnect the mains plug from the

socket. The light in the display goes out.

Automatic shut-off function

The appliance has an automatic shut-off function.

• If the iron station is not in use it will shut off after 20 min-

utes. The red control lamp in the display ashes.

• Use the selector button SET (11) to reset the desired

temperature, if you want to continue ironing.

Function of the Handle (8)

The handle attached to the base serves for carrying the appli-

ance when the mains plug has been pulled from the outlet.

• To carry the appliance, raise the

handle until it engages (Fig. A).

A “click” conrms that the handle

has been locked. You can use the

handle for transport of the appli-

ance.

• To unlock the handle lock, press

both buttons “UNLOCK” (6) at the

same time and lower the handle

(Fig. B).

Electronic temperature adjustment using the selector but-

ton SET (11)

• Observe the ironing instructions on the clothes label.

• Select the temperature setting according to the following

table.

• Turn woolen clothes inside out to avoid shiny spots on the

fabric due to steam ironing. In addition, lay a thin cotton

cloth onto the fabric.

• The instructions in the table only refer to fabrics with no

additional surface treatment (gloss, impregnation, wrinkles,

etc.). Select a low temperature setting for fabrics with ad-

ditional surface treatment and iron them inside out.

• Press the selector button SET (11) to set the desired

temperature.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann DBS 783 CB Seite 39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info