Bedienungsanleitung Bomann DT 247 (Seite 9 von 11) (Englisch)

552176

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

12/2011

Defrosting

The fridge has a automatic defrosting system. During defrosting the water drops drain off at the rear

side of the cooling chamber. The water running through a flume, is collected in a container under-

neath the compressor, where it will evaporate. Make sure the flume does not get clogged. Clean it

carefully with a pipe cleaner or knitting needle. A light formation of ice on the rear side during opera-

tion is normal.

To achieve better cooling and to save energy, defrost the freezer regularly. To start the defrosting

process turn the temperature control to the position 0 - OFF and disconnect the plug. Remove the

food items and keep covered at a cool location.

When the ice has melted, pour the condensate away and dry the interior of the device.

You may then restart the device by connecting the plug and turning the temperature control.

WARNING

Never use metal objects (e.g. knives) for removing ice from the vaporizer. The vaporizer could be

damaged. A defect vaporizer could cause serious damages.

Operating noise

NORMAL NOISE

TYPE OF SOUND

CAUSE/

SOLUTION

Mumbling

Caused by the compressor during its operation.

This is stronger when it turns on or off.

Liquid sounds

Caused by the circulation of the refrigerant in the

device.

Click sounds

The temperature control turns the compressor on or

off.

Disturbing noises

Vibration of the shelves or cooling coils – check if

those are securely fastened.

Turning off

Turn the temperature to setting 0 – OFF in order to turn off the device.

If the device will not be operated for a longer period of time:

• Remove the entire food from the device.

• Turn the temperature control to setting 0 - OFF.

• Disconnect the plug or turn off / unscrew the fuse.

• Thoroughly clean the device (refer to chapter of “Cleaning and Care”).

• Keep the door open in order to prevent bad odors.

TIPS FOR ENERGY SAVING

• Disconnect the plug if you do not use the device.

• Do not install the device near stoves, heaters or other heat sources. In case of higher ambient

temperatures, the compressor will run more frequently and longer.

• Ensure sufficient ventilation at the bottom and rear side of the device.

Never block any ventilation openings.

• Allow warm dishes to cool down before putting them in the device.

• Do not open the door longer then necessary.

• Only set the temperature as low as needed. The ideal temperature in the fridge is 7°C.

It should be measured in the upper shelf, as far as possible in the front.

• Make sure that the temperature in the freezer does not rise above -18°C.

• The freezer should be defrosted regularly.

• Always keep the condenser – metal grid on the rear side (if existing) – clean.

• Make sure the door sealing is in good order for the door to close properly.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann DT 247 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bomann DT 247

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info