Bedienungsanleitung Bomann DT 347 (Seite 18 von 28) (Deutsch, Englisch)

652481

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Electr

ElectrElectr

Electrical connection

ical connectionical connection

ical connection

WARNING:

WARNING:WARNING:

WARNING:

• The installation to the mains supply must conform

to the local standards and regulations.

• Improper connection may cause to an electric

electric electric

electric

shock

shockshock

shock!

• Do not modify the appliance plug. If the plug does

not fit properly to the outlet, let install a proper

outlet by an authorized specialist.

• The accessibility of the power plug must be en-

sured to disconnect the appliance from the power

supply in case of emergency.

CAUTION

CAUTIONCAUTION

CAUTION:

In case of disconnection or power failure:

- Wait for approx. 5 minutes before restarting.

- Check the operation settings.

• Ensure that your mains power corresponds with

the specifications of the appliance. The specifica-

tions are printed on the rating label.

• Connect the mains cable to a properly installed

and earthed wall outlet.

• If the plug after installation is not accessible, a

corresponding disconnect device must be availa-

ble to meet the relevant safety regulations.

Reverse the

Reverse the Reverse the

Reverse the door o

door odoor o

door opening

peningpening

pening

If required, the door openings can be moved from the

right (supplied condition) to the left side.

WARNING:

WARNING:WARNING:

WARNING:

When replacing the door stops, the appliance must

be disconnected from the power supply.

NOTE

NOTENOTE

NOTE:

• When installing, ask another person to assist.

•

You possibly need:

screw wrench, Phillips screw-

driver as well as a thin-blade screwdriver.

• Remove the cover caps on

the top cover. Loosen the

screws underneath and re-

move the top cover.

• Dismount the upper door hinge.

Open the freezer door a little and

lift it out of the middle door hinge.

Place the door safely aside.

• Move the screws and the

plastic cap on the opposite

side.

• Dismount the middle door hinge.

Open the fridge door a little and

lift it out of the lower door hinge.

Place the door also at a safe place.

• Move the cover caps on the

opposite holes.

• Tilt the appliance slightly back-

wards and block it in this position.

Unscrew the feet and dismount the door hinge.

• Attach the door hinge at the other appliance side,

after you have unscrewed the

hinge pin and used it from the

other hinge side. Turn in the feet accordingly.

• Replace the appliance upright. Put on the fridge

door and fix it in its intended position.

• Turn the middle door hinge about 180° and trans-

fer it at the opposite side. Put the hinge pin in the

hole of the fridge door and fasten the hinge.

• Put on the freezer door and fix it in its intended

position.

• Transfer the upper door hinge at the opposite

side, after you have unscrewed

the hinge pin and used it from the

other hinge side. Put the hinge pin in the hole of

the freezer door and fasten the hinge.

• Replace the appliance cover, which you have

removed at the beginning. Tight the screws and

clip the screw covers on.

• Check if the doors are aligned vertically and hori-

zontally optimally so that the smooth opening and

closing of the doors is guaranteed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann DT 347 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info