Bedienungsanleitung Bomann ES 1185 CB (Seite 57 von 98) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

651946

Zoom out

Zoom in

Vorherige Seite

1/98

Nächste Seite

ES1185CB_IM 04.03.16

6. Briey open the steam control knob (3) towards “+” every

time before using the frothing function to drain collected

condensate. The appliance is ready to use if only steam

escapes.

7. Place your milk jug with the milk under the steam nozzle.

8. Lift the jug so that the steam nozzle sits just under the

milk surface.

NOTE:

Do not place the steam nozzle in the centre of the jug

but close to the inner wall. This position is important

for the milk to get into whirling motion. We recommend

using the spout as guide for the steam nozzle.

9. Slowly open the steam control knob (3) towards “+” until

the desired amount of steam is set. Slightly move the jug

up and down. Close the steam control knob towards

“OFF” after the milk has frothed to the desired volume

(approx. 50 %).

NOTE:

• To further heat up the milk insert the steam nozzle

all the way to the bottom of the jug. Ensure that the

milk does not start boiling. In this case the foam will

collapse.

• The water is no longer hot enough if the indicator

lamp (11) turns off during frothing. Turn the steam

control knob towards “OFF”. Wait until the indicator

lamp “ok” lights up again. Now continue frothing the

milk.

10. To remove the last coarse air bubbles knock the milk jug

after frothing carefully on the tabletop (as if you would

set it down a bit hard). Swivel the milk jug slightly around.

This helps to mix the foam after frothing. Now waste no

time. Pour the frothed milk slowly into the espresso.

11. Swivel the milk jug slightly around while pouring the

frothed milk slowly into the espresso.

NOTE:

• With a few artful movements you can draw designs

into the foam.

• Sprinkle cocoa powder or cinnamon to taste on the

foam.

12. IMPORTANT: Clean the steam nozzle immediately after

every use! When closing the steam control knob a vac-

uum is created within seconds, which draws some milk

into the steam nozzle. Place your heat-resistant container

under the steam nozzle. Open the steam control knob

briey for a shot of steam to ush milk residue out of the

steam nozzle. Wipe the steam nozzle with a damp cloth.

13. Turn off the steam function by setting the switch (10) to

the position ““.

Cleaning

WARNING:

• Before cleaning, always remove the mains plug and wait until the

device has cooled down.

• Do not immerse the device in water. Otherwise this might result in

an electric shock or re.

• The steam nozzle is hot immediately after use!

CAUTION:

• Do not use a wire brush or any abrasive items.

• Do not use any acidic or abrasive detergents.

• Clean the casing with a slightly damp cloth without

detergents.

Group Head and Rubber Seal

Wipe group head and rubber seal with a damp cloth. Use

a soft nylon brush to remove stubborn residues. Dry with a

soft cloth.

Accessories

Wash lter holder, lter inserts, drip tray grid, drip tray, meas-

uring spoon, water tank and steam nozzle cover in warm

sudsy water. Use a soft nylon brush, if necessary. Rinse with

clean water. Dry all parts with a soft cloth.

CAUTION:

These parts are not dishwasher-safe. Heat and aggressive

detergents can cause distortion and decolouration.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann ES 1185 CB Seite 57

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info