Bedienungsanleitung Bomann GSP 5707 (Seite 16 von 20) (Englisch)

552048

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

12/2011

Cleaning the Spray Arms

It is necessary to clean the spray arms regularly for hard water chemicals will clog

the spray arm jets and bearings.

To remove the upper spray arm, screw off the nut clockwise then remove the arm.

To remove the lower spray arm, pull out the spray arm upward. Wash the arms in

soapy and warm water and use a soft brush to clean the jets. Replace them after

rinsing them thoroughly.

How to keep your Dishwasher in Shape

NSTALLATION

NSTRUCTION

The dishwasher should not stand on top of the water hoses or the electricity supply cable and the in-

stallation of the pipes and electrical equipments should be done by professionals.

WARNING

Electrical Shock Hazard! Disconnect electrical power before installing dishwasher.

Failure to do so can result in death or electrical shock.

Positioning the Appliance

Position the appliance in the desired location. The back should rest against the wall behind it, and the

sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain

hoses that can be positioned either to the right or the left sides to facilitate proper installation.

The power cord should be easily accessible.

The dishwasher can be installed under a working cover by following the steps of below pictures.

Leveling the Appliance

Once the appliance is positioned for leveling, the height of the dishwasher may be altered via adjust-

ment of the screwing level of the feet. In any case, the appliance should not be inclined more than 2°.

The max. adjusting height of the feet is 20 mm.

If the appliance is leveled correctly, it will be more stable and much less likely to move or cause vibra-

tions and noise while it is operation.

After Every Wash

After every wash, turn off the water supply to the

appliance and leave the door slightly open so that

moisture and odours are not trapped inside.

- Remove the Plug

Before cleaning or performing maintenance, al-

ways remove the plug from the socket.

- No Solvents or Abrasive Cleaning

To clean the exterior and rubber parts of the dish-

washer, do not use solvents or abrasive cleaning

products. Only use a cloth with warm soapy water.

To remove spots or stains from the surface of the

interior, use a cloth dampened with water a n a lit-

tle vinegar, or a cleaning product mad e specifical-

ly for dishwashers.

When not in Use for a Long Time

It is recommend that you run a was h cycle with

the dishwasher empty and the n remove the plug

from the socket, turn off the water supply and

leave the door of the appliance slightly open. This

will help the door seals to last longer and prevent

odours from forming within the appliance.

- Moving the Appliance

If the appliance must be moved, try to keep it in the

vertical position. If absolutely necessary, it can be

positioned on its back.

- Seals

One of the factors that cause odours to form in the

dishwasher is food that remains trapped in the

seals. Periodic cleaning with a damp sponge will

prevent this from occurring.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann GSP 5707 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bomann GSP 5707

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info