Bedienungsanleitung Bomann GSP 850 (Seite 6 von 24) (Englisch)

688022

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

• Take care of a solid and horizontal position of the appliance. If the appliance is not horizontally leveled,

adjust the feet accordingly.

• Power cable and water hoses may not kinked or squashed.

• Avoid the installation:

Avoid the installation:Avoid the installation:

Avoid the installation:

- near heaters, next to a stove, direct sunlight or any other heat sources;

- at locations with high humidity (e.g. outdoors), as metal parts would be susceptible to corrosion under

such circumstances;

- in rooms where the temperature could drop below freezing. Do not expose the appliance any weather.

- near volatile or flammable materials (e.g. gas, fuel, alcohol, paint, etc.).

Water co

Water coWater co

Water connection

nnectionnnection

nnection

CAUTION:

CAUTION:CAUTION:

CAUTION:

• The Installation of the water supply must conform to the local laws and regulations.

• Use the new supplied hose set to connect the appliance to the water supply. Do not reuse old or used

connection sets.

• If the water pipe is new or long time not used, ensure before connecting to the water system, that the water

is clear and free from contamination.

Notes

Notes Notes

Notes on inlet hose safety system (

on inlet hose safety system (on inlet hose safety system (

on inlet hose safety system (included in delivery)

included in delivery)included in delivery)

included in delivery)

The safety system consists of a double-walled inlet hose. This system guarantees to cut off the water supply

when leakage of the inner hose. Switching off the water supply leads over an electronic contact.

Connect the water

Connect the water Connect the water

Connect the water inlet

inletinlet

inlet

hose (cold water connection)

hose (cold water connection)hose (cold water connection)

hose (cold water connection)

NOTE

NOTENOTE

NOTE:

The water pressure must be between 0.04 and 1 MPa. With higher pressure: use a pressure regulator.

• Connect the water inlet hose to a water thread with ¾“. Screw the hose firmly in the direction

of the screw thread; pay attention for a tight fit.

• Connect the other end of the inlet hose to the inlet valve on the appliance back; pay attention

for a tight fit too.

Hot water supply

Hot water supplyHot water supply

Hot water supply

The dishwasher can be supplied with a water temperature of not more than 60°C. Supplying the appliance

with hot water, the rinse running time is shortened but the cleaning effect can be slightly reduced. The con-

nection to the hot water valve must be done in the same manner as described for the cold water connection.

Connect the water drain hose

Connect the water drain hoseConnect the water drain hose

Connect the water drain hose

NOTE

NOTENOTE

NOTE:

The drain hose has a length of approx. 1.5 m and can extend with a suitable hose and connecting piece to a

length of max. 4 m.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann GSP 850 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bomann GSP 850

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info