Bedienungsanleitung Bomann GSP 875 (Seite 21 von 25) (Englisch)

552082

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

for personal safety:

DO NOT U SE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIAN CE.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE

FROM THE POWER CORD.

EAR THING

CONNECTION

WARNING!

Improper connection of the equipment earthing conductor can result in the risk of an

electric shock.

Check with a qualified electrician or service representative if you are in doubt whether the

appliance is properly earthed.

Do not modify the plug provided with the appliance. If the plug does not fit properly to the

outlet, please have a qualified electrician to install a proper outlet.

Ahose that a ttaches to a sink spra y can burst i f i t is ins talle d on th e sam e wa ter line as th e dishwash er. If your sink

has one, it is reco mm ended that the ho se be d isco nnected and the hol e plug ged .

Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher .

T urn water fully on before sta rting the dishwasher.

Tighter the screws of the safety supply hose to the faucet with thread 3 /4inch.

Th e sa fe ty suppl y hose consists of t he dou ble wall s. The hose's sy s tem gua ran tees its in terventi on b y blo ck ing th e

flow of wate r in c ase of the su pply hos e breaki ng a nd when the air spac e bet wee n the su pply hos e its elf a nd the oute r

corruga t ed hos e is full of wat e r.

Turn off the water.

Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the

room, from severe splashing.

Unscrew the saf ety supply hose from the faucet.

The applian ce must be c onne cte d to the w ate r mains using new hos e-sets.

The old hose-se ts should no t be reused.

Water pressure must b e bet wee n 0,0 4 M Pa a nd 1 MPa. If the pressure is b elow the

min imum c onsult ou r Ser vic e Depar tment for advice.

Connect th e cold water supply hose to a thr ead ed 3/ 4(inch ) conn ector an d make sure that i t is fastened tightl y in pl ace.

If th e water p ipes are new or have no t been used for an ext ended pe riod of ti me, let the water run t o mak e sur e that the

water is clear and free of impuriti es. If t his precautio n is no t taken, there is a risk th at the water inl et can g et bl ocked

and dama g e th e a pp liance.

The water su pply t o the appliance can a lso be connect ed to the house ho t water l ine (cent ralize d system, heat ing

system) ,a s long as it does n ot exce ed a temperatur e of 60 C . In this ca se, t he wash cycl e time w ill be shorten ed by

about 15 minutes a nd the wash e fficie ncy slig htly redu ced .

The connecti on must be made to the hot wat er lin e follo wing th e same procedures as t hose f or the conn ection t o the

cold water line.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann GSP 875 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bomann GSP 875

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info