Bedienungsanleitung Bomann GSPE 7415 VI (Seite 34 von 44) (Deutsch, Englisch)

814372

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

• To open the dispenser, screw the lid counter-

clockwise to the open position and remove the lid.

• Add the rinse aid into the dispenser, being careful

not to overfill. The dispenser contains approx.

110 ml.

• Before closing the appliance door, put on the lid in

the open position back and turn it clockwise to the

closed position.

NOTE:

Remove spilled rinse aid with an absorbent cloth to

avoid excessive foaming during the next rinse.

Adjusting the rinse aid dosage

When forming spots and the dishes dries poorly,

increase the added amount of rinse aid. You can set

the amount of addition between level 1 (min.) and

level 6 (max.).

Take off the lid of the rinse aid dis-

penser and adjust the dial to the de-

sired level. The factory setting is “4”.

NOTE:

Increase the dosage if there are drops of water or

lime spots on the dishes after rinsing. Reduce the

dosage if there are sticky whitish stains on dishes or

a bluish film on glassware or knife blades.

C. Fill in detergent

Function of detergent

Detergents with its chemical ingredients are neces-

sary to remove dirt, crush dirt and transport it out of

the dishwasher. The most commercially, high-quality

cleaning agents are suitable for this purpose.

Detergent

Normally new pulverized detergent is without phos-

phate. Thus, the water softener function of phos-

phate is not given. In this case we recommend filling

salt in the salt container even when the hardness of

water is only 6°dH. If detergents without phosphate

are used in the case of hard water often white spots

appear on dishes and glasses. In this case add more

detergent to reach better results. Detergents without

chlorine do only bleach a little. Strong and colored

spot will not be removed completely. In this case

choose a program with a higher temperature.

Detergent tablets (tabs)

Dishwasher tablets from different manufacturers

dissolve at different rates. It is possible that they will

not fully dissolve in programs with short running time

and low water temperature and thus does not reach

their full productive efficiency. To ensure the com-

plete removal of detergent residues, we recommend

choosing rinse programs with long running times and

high-water temperature. Always follow the manufac-

turer's instructions!

Fill in the detergent

NOTE:

• Always add the detergent just before starting the

rinse cycle, otherwise it could get damp and will

not dissolve properly.

• You’ll find information about the amount of deter-

gent for the respective programs in the

“Program

table“

. Note that depending on the degree of soil-

ing and water hardness differences are possible.

• At the end of the rinse cycle the detergent dis-

penser must be empty.

The dispenser must be refilled before the start of

each rinse cycle according to the instructions in the

"Program table"

• Press the release button to open the dispenser.

A Chamber of detergent in powder form for the

main rinse

B Chamber of detergent for the pre-rinse /

Chamber for detergent in tablet form

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann GSPE 7415 VI Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info