Bedienungsanleitung Bomann KA 1565 CB (Seite 30 von 56) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

552023

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

NOTE:

Production residue or dust may have collected on the appli-

ance. We recommend cleaning the appliance according to

chapter “Cleaning”.

Instructions

Placement

• Place the automatic coffee maker on a stable and level

surface. Place the appliance in such way that it cannot tip

over.

• Do not place the appliance in close proximity to a gas or

electric stove or any other heat source.

Electric Connection

NOTE:

Make sure the device is switched off. The switch must be at

the “0” position.

1. Ensure that your mains power corresponds with the speci-

cations of the appliance. The specications are printed on

the type label.

2. Connect the mains cable to a properly installed and earthed

wall outlet.

Operation

Before making coffee for the rst time operate the appliance

twice with clean water only and without paper lter. This re-

moves dust, which may have collected during transport. Follow

the instructions given under “Operation”.

Operation

1. Open the lid of the water tank.

2. Fill cold water according to the desired amount of cups of

coffee into the rear water tank. The water level is displayed

on the indicator.

NOTE:

You can use the pot to ll the water tank.

CAUTION:

Do not overll the tank! Do not ll it above the MAX mark.

3. Ensure that the lter holder is properly attached.

4. Turn over the lower fold of the paper lter (size 1x4) and

place it in the lter funnel. Then ll it with coffee powder.

5. Now close the lid of the water tank.

6. Place the jug onto the warming plate.

CAUTION: Drip stop

Your appliance comes with a drip stop. It closes when

removing the coffee pot. This prevents the coffee from

dripping onto the warming plate if there is still water in the

lter.

• Ensure that the lid is attached to the coffee pot. It

opens the drip stop.

• If there is still water in the tank, place the pot under-

neath as soon as possible. Otherwise the lter might

overow.

7. Switch on the device. The indicator lamp in the switch will

light up.

The Coffee Is Ready

NOTE:

The brewing process lasts approximately 10 minutes.

• When no more coffee is owing through the lter you can

remove the pot.

• Turn the device off.

• Would you like to keep the remaining coffee warm? Leave

the machine switched on until the pot is empty.

NOTE:

The lter holder can be removed from the machine by its

handle .

This makes it easier to dispose of the old coffee lter, for

example.

WARNING:

If you want to make another pot of coffee immediately, switch

off the device rst. Let it cool down with the water tank open

in order to avoid hot water splashing when relling with water.

De-scaling

De-scaling is necessary when the brewing time increases

substantially.

• Use only commercially available citrus acidbased de-scaler.

• Follow the recommended instructions for use.

WARNING:

• Afterwards you should boil fresh water in the pot three or

four times in order to rinse out residues of the descaling

agent.

• Do not use any coffee powder!

• Do not use this water for consumption.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann KA 1565 CB Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info