Bedienungsanleitung Bomann km 345 cb (Seite 42 von 66) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Norwegisch)

380711

Zoom out

Zoom in

Vorherige Seite

1/66

Nächste Seite

ENGLISH

CAUTION:

Do not use the mixer and the grater bowl at the same

time.

Mains Lead

Unwind the required mains lead from the base.

Initial Operation

Mixer function

1. The grater bowl (10) must be mounted as described in the

section „Positioning the Grater Bowl“ (without tool).

2. Chop the food to be mixed into small pieces.

3. Fill the mixer vessel (3) with the food to be mixed (min. 0.2 l

- max. 1.5 l). Never ﬁ ll with hot food or hard ingredients such

as potatoes, ice, coffee beans, nuts, and so on. Do not

overﬁ ll! Do not exceed the maximum quantity stated on the

mixing bowl!

CAUTION: SAFETY SWITCH!

The device only works if the grater bowl (10) with lid is

also in place.

4. Put the lid (4) in place and turn it tight.

5. Close the lid with the lock (5), paying attention to the reces-

ses. Turn the lock until it is tight.

6. Place the mixing bowl (3) in position as described under

„Positioning the Mixing Bowl“.

7. If you wish to ﬁ ll in more food to be mixed you can remove

the lid and cover. Switch the device off beforehand. Remove

the lid (4) of the mixer vessel and ﬁ ll with the desired ingredi-

ents.

WARNING:

Do not reach into the mixer vessel, as the underlying

blade may cause injuries.

8. Place the lid on the mixer vessel again. Do not use the mixer

when empty or without the lid. Ensure that the function

switch is in the „0“ position.

9. Insert the plug in a duly installed 230 V/50 Hz socket.

10. Switch the device on (Level 1 or 2 etc.) or use pulse operati-

on (PULSE).

11. The mixing bowl must be held ﬁ rmly in place during mixing.

12. For constant mixing (continuous mode):

When the device is operated on levels 1 to 4 the switch

locks into place in the respective position.

Level 1 = low rpm

Level 4 = high rpm

To switch the device off, turn the switch back to the „0“

position.

For pulse mode (mixing at brief intervals) shift the switch

to „0“ position. The appliance is off now. Please press the

PULSE (20) button. Keep the button pressed down in this

position according to the desired interval length. When

the button is released, it automatically returns to the „off“

position.

13. In order to remove the mixer jug turn it counterclockwise.

14. Clean the used parts as described in „Cleaning“.

Mixing bowl

• The cover of the mixer drive (7) must be mounted as descri-

bed above.

• Mount the grater bowl as described under „Positioning the

Mixing Bowl“.

• Place the locating pin over the drive shaft (Illustration 5).

The metal point faces upwards.

• Never use more than one utensil at a time.

Dough kneading and beating

1. Take the plastic blade (16) for preparing the dough and

attach it to the locating pin. Then press the Messer down as

far as it will go (Illustration 6).

2. Now ﬁ ll in your ingredients. Please note the markings on the

processor bowl and do not ﬁ ll it above them (min 0.2 l - max.

0.8 l).

3. Place the lid in position on the processor bowl. Turn it tight

until it is clearly heard to lock in place (Illustration 7).

4. Close the opening in the lid with the stopper (17).

5. Insert the plug into a 230 V / 50 Hz socket installed accor-

ding to existing regulations and with earthing protection.

Switch on the appliance and set a speed between 1 and 3

(See table) with switch (1).

When the device is operated on levels 1 to 4 the switch

locks into place in the respective position.

Level 1 = low rpm

Level 4 = high rpm

To switch the device off, turn the switch back to the „0“

position.

For pulse mode (Operating at short intervals) shift the switch

to „0“ position. The appliance is off now. Please press the

PULSE (20) button. Keep the button pressed down in this

position according to the desired interval length. When

the button is released, it automatically returns to the „off“

position.

With this device it is possible within a very short time:

• up to 600 g of heavy dough (bread or pastry),

• beat up to 800 g of crepe or wafﬂ e batter,

• beat up to 800 g of light dough (e.g. for cookies).

ޥ NOTE:

Do not exceed the short operation times stated in the table

when kneading the dough!

6. After kneading/stirring turn the switch (1) back to position

„0“ as soon as a small amount or ball of dough has formed.

Then remove the mains plug.

7. Turn the lid to the left and remove it from the processor

bowl.

8. Pull the blade off from the locating pin.

9. Release and remove the grater bowl and the locating pin.

The ﬁ nished dough can be released from the sides and with

a spatula (18) and taken out of the bowl.

10. Clean the used parts as described in „Cleaning“.

05-KM 345 CB 42 14.11.2006, 9:27:59 Uhr

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann km 345 cb Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info