Bedienungsanleitung Bomann KM 399 CB (Seite 41 von 70) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

651966

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

KM399CB_IM 22.02.16

CAUTION:

• The projection on the knife block must be in the recess

of the screw-on base.

• Never forget to place the seal ring onto the knife block,

as otherwise the mixing jug will leak.

• Never screw in the screw-on base inclined.

Operation

1. Fill the chopped ingredients into the mixing jug.

2. Press the lid tightly onto the mixing jug.

3. Close the lling opening with the cap. Set the cap into the

lling opening and tighten it by turning it anticlockwise.

4. Set the rotary control to “0”.

5. Make sure that the arm has been lowered and is

engaged.

6. Remove the safety cover (2) from the drive shaft of the

mixer drive. Press and shift the grooved surface.

7. Set the mixing jug onto the drive shaft of the mixer drive.

Set the mixing jug with the arrow

over the dot of the

base unit. Turn the mixing jug clockwise up to the stop.

The two arrows and must be one above the other.

8. Plug the power plug into a certied outlet.

9. Select a speed.

NOTE:

• Short-interval operation: When mixing, do not operate

the appliance for longer than 2 minutes. Allow to cool for

1 minute before using it again.

• To rell with ingredients, switch off the appliance.

Remove the cap or the lid. Continue operation only with

the attached lid and closed rell opening.

Ending Operation

1. Set the control knob to “0”.

2. Disconnect the mains plug.

3. Remove the mixing vessel.

4. Remove the lid before pouring out the ingredients.

5. Clean the used parts as described under “Cleaning”.

6. Cover the motor shaft of the mixer motor with the safety

cover.

IMPORTANT NOTE:

Never keep citrus juices or acidic foodstuffs in metal

containers.

Cleaning

WARNING:

• Disconnect from mains power supply before cleaning.

• Do not submerge the appliance into water. This may lead to elec-

tric shock or re.

• The knives of the mixing vessel are sharp. Risk of injury!

CAUTION:

• Do not use a wire brush or other abrasive utensils for

cleaning.

• Do not use aggressive or abrasive cleaning agents.

Motor Housing

Clean the housing only with a damp cloth and a squirt of

washing-up liquid.

Mixing Bowl, Kneading and Mixing Attachments

CAUTION:

The attachments are not suitable for dishwasher. Heat

and aggressive cleaning agents may warp or discolour the

attachments.

• Parts which have come into contact with food can be

rinsed out with water.

• Leave the parts to dry properly before re-assembling the

appliance.

Accessories of the Mixer

NOTE: Pre-cleaning

Fill the mixing container half with water and run the appli-

ance for approx. 10 seconds. Dispose of the liquid.

WARNING: Risk of injury!

The knives on the knife block are sharp. Be careful when

disassembling, cleaning, and assembling the individual

parts.

• To clean properly, remove the mixing vessel.

• Disassemble the mixing jug after each use.

• Unscrew the screw-on base from the mixing jug.

• Remove the knife block and the seal ring from the screw-

on base.

• The glass carafe of the mixing jug and the lid can be

cleaned in a warm rinsing bath. Rinse with pure water

and dry.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann KM 399 CB Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info