Bedienungsanleitung Bomann KSE 337 (Seite 19 von 28) (Deutsch)

652036

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

CAUTION

CAUTIONCAUTION

CAUTION:

In case of disconnection or power failure:

- Wait for approx. 5 minutes before restarting.

- Check the operation settings.

• Ensure that your mains power corresponds with

the specifications of the appliance. The specifica-

tions are printed on the rating label.

• Connect the mains cable to a properly installed

and earthed wall outlet.

• If the plug after installation is not accessible, a

corresponding disconnect device must be availa-

ble to meet the relevant safety regulations.

Reverse the

Reverse the Reverse the

Reverse the door o

door odoor o

door opening

peningpening

pening

If required, the door opening can be moved from the

right (supplied condition) to the left side.

WARNING:

WARNING:WARNING:

WARNING:

When replacing the door stop, the appliance must be

disconnected from the power supply. Always unplug

the appliance first.

NOTE

NOTENOTE

NOTE:

• When installing, ask another person to assist.

•

You possibly need:

screw wrench, Phillips screw-

driver as well as a thin-blade screwdriver.

• Dismount the upper limit plate incl. hinge pin by

loosening the screws. Open the door a little and

take it carefully off the lower door hinge. Place the

door on a padded surface to prevent it from

scratches.

• Tilt the appliance slightly backwards and block it

in this position. Loosen the lower hinge pin and

put it in the opposite bracket.

• Replace the appliance upright again. Insert the

appliance door on the lower hinge pin and fix the

door to the property position.

• Attach the upper limit plate after you have un-

screwed the hinge pin and used it on the other

side of the plate. Insert the hinge pin in the hole of

the appliance door and tight the plate.

• Check if the door is arranged vertical as well as

horizontal, so that a smooth opening and closing

of the door is ensured.

Reverse the freezer door opening

Reverse the freezer door openingReverse the freezer door opening

Reverse the freezer door opening

• Open the freezer door a little. Using a small

screwdriver, press the spring of the lower bracket

slightly upwards and remove the holder together

with the freezer door.

• Position the blind cap (M) on the opposite side.

• Turn the freezer door about 180° and press the

lower bracket into the appropriated fixture of the

freezer compartment.

• Lift the freezer door slightly a little and attach it to

the upper bracket, simultaneously press the lower

bracket into the square hole. Small adjustments

up and down facilitate the attachment of the

freezer door.

Built

BuiltBuilt

Built-

-in

inin

Built-in openings

Height x Width x Depth

1218–1226 x

560–570 x 550 mm

Figures in mm

For the appropriate venting an exhaust duct of

approx. 50 mm depth is to provide at the appliance

back.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann KSE 337 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bomann KSE 337

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info