Bedienungsanleitung Bomann KSG 232 (Seite 5 von 10) (Englisch)

552275

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

05/2013

Operating noise 40 dB(A) 40 dB(A)

Maximum Loading of top shelf 21 kg 32 kg

Maximum Loading of bottom shelf 17 kg 18 kg

Unit Dimension H x W x D 84.5 x 50.5 x 53.4 cm 140.2 x 54.5 x 57.0 cm

Unit Dimension in Services H x W x D 84.5 x 88.5 x 110.0 cm 140.2 x 99.5 x 107.0 cm

Gross / net weight 32.0 / 29.0 kg 51.0 / 47.0 kg

Coolant R600a (18g) R600a (27g)

Light max. 10 W 10 W

According ISO 23953-2 , the climate class as below

Climate Class

Temperature ℃

Relative humidity (%)

0 20 50

1 16 80

2 22 65

3 25 60

4 30 55

5 40 40

6 27 70

(2)

The actual energy consumption depends on the use and installation of the device.

The actual energy consumption depends on the usage and might therefore also be above the values determined by

the manufacturer under standard conditions. An expert knows these relations and will execute the tests with special

measurement instruments in accordance with the regulations in place.

MANUFACTURER DATA: Product is subject to changes and improvements.

NSTALLATION

Location

Sufficient ventilation around the device is necessary in order for the heat to dissipate properly and to

guarantee efficient cooling operation at low power consumption. For this purpose, leave sufficient

space around the device.

- Minimum clearance of 5 cm between rear side and wall,

- at least 10 cm on both sides.

IMPORTANT:

- Do not expose the device to direct sunlight.

- Do not place near heaters, next to a stove or any other heat sources.

- Do not use the device outdoors.

- Only install at a location with an ambient temperature suitable for the climate class of the device.

For information on the climate class, please refer to chapter “Specifications“ or to the rating label

located in the interior or on the rear side of the device.

- Avoid installation at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be

susceptible to corrosion under such circumstances.

- Do not place the device near volatile or combustible materials (e.g. gas, fuel, alcohol, paint, etc.)

and in rooms which may have poor air circulation (e.g. garages).

Electrical connection

The kind of current (AC) and the voltage must be conform to the data of the rating label, located inside

or outside on the back of the unit. In case of heavy voltage fluctuations, it is recommended to use an

automatic alternating current regulator.

The plug, together with the grounding conductor, must fit into the wall socket. The mains plug must be

freely accessible.

Mains cable

- Do not extend or roll up the cable during operation.

- Also, the cable must not be near the compressor on the rear side, since latter one gets hot during

operation. In case of any contact, the isolation would be damaged resulting in electric leakage.

- The use of extension cables is not recommended.

- Do not connect the device to the mains with wet hands.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann KSG 232 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bomann KSG 232

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info