Bedienungsanleitung Bomann KSG 7351 (Seite 18 von 24) (Deutsch, Englisch)

814358

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

- Gap to the back approx. 50～70 mm, to the

side walls and above the appliance each ap-

prox. min. 100 mm;

- Place the appliance so that the appliance door

can open without being impeded.

• Only install at a location with an ambient tempera-

ture suitable for the climate class of the appliance.

The climate class can be found under

"Technical

data"

and on the rating label located in the interior

or on the appliance rear.

• Place the appliance on a steady and safe surface.

If the appliance is not horizontally leveled, adjust

the feet accordingly.

• Avoid the installation:

- near heaters, next to a stove, direct sunlight or

any other heat sources;

- at locations with high humidity (e. g. outdoors,

bathroom), as metal parts would be suscepti-

ble to corrosion under such circumstances;

- near volatile or flammable materials (e. g. gas,

fuel, alcohol, paint, etc.), in rooms which may

have poor air circulation (e. g. garages).

- Do not expose the appliance any weather.

Leveling the appliance

Slight unevenness in the floor can be leveled out us-

ing the front feet.

Check whether the appliance is leveled horizontally.

If the appliance is not in balance, the feet must be

adjusted.

Electrical connection

WARNING:

• The installation to the mains supply must conform

to the local standards and regulations.

• Improper connection may cause to an electric

shock!

WARNING:

• Do not modify the appliance plug. If the plug does

not fit properly to the outlet, let install a proper

outlet by an authorized specialist.

• The accessibility of the power plug must be en-

sured to disconnect the appliance from the power

supply in case of emergency.

CAUTION:

Do not switch on the appliance immediately after a

power interruption. Overloading of the compressor or

blowing of the fuse is possible.

• Make sure that the voltage supply matches the

specifications on the rating label before connect-

ing.

• Connect the mains cable to a properly installed

and earthed wall outlet.

• If the plug after installation is not accessible, a

corresponding disconnect device must be availa-

ble to meet the relevant safety regulations.

Startup / Operation

Intended use

The appliance is intended for commercial use and for

the purpose intended for it. It is suitable for storage,

presentation and sale of chilled beverages.

This cooling unit is not suitable for freezing food!

Prior to first use

CAUTION:

After transport, the appliance should be left standing

upright for four hours before connecting to the power

supply. Nonobservance could lead to malfunction of

the cooling system and causes an appliance break-

down.

Clean the appliance interior including all accessory

parts. Consider the instructions which we provide in

the chapter

“Cleaning and maintenance”

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann KSG 7351 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info