686434
18
Zoom out
Zoom in
Vorherige Seite
1/26
Nächste Seite
18
MWG3001HEB_IM 12.07.2018
Installation Instructions
This microwave oven must be installed in a tall cupboard. Please note the
following instructions:
Remove everything that is fragile from the adjacent cupboards.
For the installation, the cupboard must meet the following conditions:
- The cupboard must not have any cracks, splinters or other damages.
All joints must be stable.
- The cupboard must be designed to support at least 40 kg.
- The microwave oven must be installed at a height of at least 85 cm.
- The rear wall of the cupboard must be removed to allow sufcient
ventilation of the microwave oven.
- The side walls of the cupboard must be at least 19 mm thick.
- The installation depth of the cupboard has to be at least 550 mm.
It is important that there is a power socket within reach of the appli-
ance´s power cable.
Check that the mains voltage is correct before you connect the plug
to the socket. You will nd the information about the appliance on the
rating label for specications.
Only connect the appliance to a tested socket.
The power socket must be easily accessible so that the plug can be
quickly removed in case of an emergency.
Important! Do not plug in the appliance until the installation has been
completed!
Further information and instructions can be found on the drilling tem-
plate provided.
WARNING:
Adhere to the dimensions given in the instructions.
Only use the included installation accessories.
Screws which are screwed in too deeply (or are too long) can dam-
age the appliance or represent a potentially fatal safety hazard.
Dimensions of the Cupboard
Prepare a built-in cupboard / niche according to the following dimensional
drawing Diagram 1.
1
Installation (Steps. 2 to 4)
2
This gure is an example only. The dimensions may vary as
these depend on the thickness of the wall cabinet.
The original drilling template is enclosed with the appliance.
Proceed as follows:
1. Check if your cabinet has a smooth, at bottom and right
size, and tape the template onto the bottom plane of
cabinet.
2. Make sure the center line of the template is in the middle of
the cabinet.
NOTE:
Make sure the front edge of template is even with the
cabinet front edge.
3. Make marks on the bottom plane of cabinet according to
the hole “X” of the template.
CAUTION:
Do not drill holes in the bottom cabinet.
4. After make marks according to the instruction, remove the
template.
5. Mount the standing feet at the marked positions.
3
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bomann MWG 3001 HEB wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info