Bedienungsanleitung Bomann SM 401 CB (Seite 28 von 50) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

651962

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

SM401CB_IM 14.12.15

Instructions for use

• Chop up large pieces of solid food before mashing (max. Ø

1.5 cm) and add a little liquid.

• Short-time operating: Do not operate the appliance

longer than 1 minute continuously. Leave the device to cool

down for at least 5 minutes before using again.

Assembly / Dismantling

WARNING: Risk of injury!

When attaching accessories there is the risk of pinching

your ngers. Please be especially careful.

Observe additional Figure on page 3. Assemble the motor

housing and the hand blender as follows:

1. Press both buttons (5) simultaneously.

2. Attach the motor casing (4) on the

blender (6) until it clicks into place.

Observe the recesses on the blender.

3. Release the buttons. Motor casing and

blender are tightly connected.

To detach press and hold both buttons simultaneously and

pull the blender from the motor casing.

Electrical connection

1. Ensure that your mains power corresponds with the speci-

cations of the appliance. The specications are printed

on the type label.

2. Connect the mains cable to a properly installed and

earthed wall outlet.

Operation

WARNING:

When using the appliance in hot foods, there is a risk of

burning due to hot splashing.

1. Submerge the entire blender head in foodstuff or bever-

age. Keep the appliance upright. In this way you avoid

spatters.

2. Hold the grip with one hand in such way that you can

press one of the push buttons (I or TURBO) at the same

time.

• Push button I (2):

This switches on the minimum speed.

• Push button TURBO (3):

This provides the maximum speed and cannot be

regulated.

3. Pulsed mode is switched on by pressing the appropriate

push button at intervals and then releasing it again.

4. The device switches itself off when the button is released.

WARNING: Risk of injury!

The motor overtravels. Wait until the knife comes to a

complete standstill.

NOTE:

Interrupt the process if the maximum speed is too slow.

Reduce the quantity of the food being mixed. First break

up any solid food.

5. Pull out the plug from the socket after use.

6. After cleaning hang the appliance on its eyelet (1).

Cleaning

WARNING:

• Always remove the plug before cleaning.

• Under no circumstances should you immerse the motor housing in

water in order to clean it. Otherwise this might result in an electric

shock or re.

• The blade of the bar mixer is very sharp! Please be very careful.

CAUTION:

• Do not use a wire brush or any abrasive items.

• Do not use any acidic or abrasive detergents.

NOTE:

Fill a container with hot water and let the blender run in it

for pre-cleaning as described under “Operation”.

• Wipe the casing with a damp cloth.

• If you want to clean the hand blender (mixing rod) thor-

oughly, detach it from the motor housing as described

under “Assembly / Dismantling”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bomann SM 401 CB Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info