Bedienungsanleitung Bompani BO243 (Seite 14 von 20) (Englisch)

476971

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

• Do not spray aerosols in the vicinity of this appliance while iy is in operation.

WARNING: Do not touch the oven heating element.

WARNING: Make sure that the appliance is switched off before changing the light bulb to avoid electric shock.

5.3 ENVIRONMENTAL PROTECTION AND SAVING

• Using the oven between late afternoon and early morning helps to reduce demand peaks.

• Keeping the oven door gaskets clean and in good condition, so that they adhere to the door ﬁrmly, reduces heat loss.

6.FOR THE INSTALLATION ENGINEER

The appliance must be installed by a qualiﬁed person, who must follow the instructions provided in this manual and in the

regulations:Law n. 46 of 05.03.1990 – Regulations on the Safety of Systems

6.1. Technical Data

Heating Element Power

Bottom heating element 1100 W

Top - bottom heating element 1100-1500 W

Fan heating element 2000 W

Oven light 15 W

Cooling fan (where installed) 22-26 W

Oven fan 25 W

Power supply voltage (50-60Hz) 240 V

Oven usable dimensions

Width mm. 411

Depth mm. 391

Height mm. 330

Volume l. 58

Usable dimensions of cavity in building-in cabinet

Height mm. 584

Width mm. 564

Depth mm. 550

6.2 Pre-Installation Procedures

• Unpack the appliance and recycle the packaging material in accordance with the relevant regulations.

• After unpacking, check the appliance for damage. If in doubt, do not use the appliance and contact a qualiﬁed professional. (See

After-Sales Service).

• The packaging materials (plastic bags, expanded polystyrene, nails, etc.) must not be left within reach of children since they are

potentially hazardous.

• Check that the accessories are in the bottom of the packaging.

• Do not make improper use of the oven door handle during transport and installation.

6.3 Building-In the Oven

• In order to allow the product to be built in correctly, the cabinet must have the following characteristics:

- the panels next to the oven must be in heat-resistant material;

- if the cabinet is in veneered wood, the adhesive used must withstand a temperature of 100°C;

- when building-in the oven, whether the installation is under-counter or in a tall unit, the cabinet must have the dimensions stated

in Fig. 1 – page 17

• Place the oven in the cabinet and screw the 4 screws fully down, using the holes provided in the facia, visible when the oven door

is opened. Make sure that the screws are inserted towards the centre of the wood in the cabinet: (see Fig.1-3-page 17). Before ﬁxing

the screws, also ensure that the oven is correctly aligned with the ﬂoor with the aid of a spirit level.

• An opening in the top of the tall unit, or a 10 mm gap above the oven surround, should be provided to ensure adequate ventilation.

(see Fig. 1 - page 17).

• If the oven is to be installed close to another appliance, check that there is no interference between the two devices when in ope-

ration.

• Once the appliance has been built in, no contact with electrical parts must be possible.

6.4 Connecting to the electrical mains

For direct connection to the mains, a mains cut-off device with a contact breaking gap that ensures complete disconnection in category

lll overvoltage conditions must be provided, in accordance with the installation rules.

WARNING: The plug must be reachable when the appliance is installed.

Useful information for the installation engineer:

• the green-yellow coloured wire must be used to make the earth connection;

• the blue wire for the neutral;

• the brown wire for the live connection;

• the cable must not touch hot surfaces with a temperature over 75°C;

• if the cable is replaced, the new one must be of H05RR-F or H05V2V2-F type of suitable gauge (see Fig. 2 – page 17);

Instructions

AUS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bompani BO243 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bompani BO243

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info