Bedienungsanleitung Bompani BO613 (Seite 16 von 52) (Englisch, Holländisch, Französisch, Italienisch)

476987

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

SEMI-AUTOMATIC OPERATION WITH COOKING DURATION

SELECTION

- Let’s take an example: it is 11:35 am and you want the oven to

stay on for 25 minutes from now on.

- Press the COOKING DURATION button and within 5 seconds press

the "+" button until it shows 00.25, adjusting the time with the

"-" button if necessary. The AUTO and PAN symbols light up

permanently.

-Turn the oven thermostat knob to the desired temperature and

the selector switch to the required cooking method; the red

warning light comes on, the oven light comes on and the oven

starts to operate.

- After 25 minutes the oven and the PAN symbol go out. The

AUTO symbol flashes and the buzzer tells you that cooking is

over: to turn off the buzzer press any button.

- Then move the oven thermostat knob and the selector switch

to the OFF position.

MINUTE MINDER

- Press the MINUTE MINDER button and choose the desired time

using the "+" or "-" button.

- The BELL symbol lights up when the minute minder is in use.

- When the pre-set time is over, the buzzer sounds and the

BELL symbol goes out.

BUZZER

- The buzzer sounds at the end of a programme and lasts for a

maximum of 7 minutes.

-To turn it off, press any button.

- Pressing the "-" button without having previously selected a

function the frequency of the signal changes. A selection from

3 possibilities can be made. The selected signal is audible as

long as the "-" button is pressed.

STARTING AND CHECKING A PROGRAMME

- The programme starts after about 4 seconds of it being set.

- The set programme can be checked at any point by pushing

the corresponding buttons.

PROGRAMMING ERRORS

- Example: at 12:15 pm a COOKING DURATION time of 30 minutes

is set and a END OF COOKING is programmed in at 12:30 pm.

- The programme error can be rectified by changing the duration

or the end of cooking time, or by pressing the MANUAL button

and programming again.

- If there is a programming error the oven will not come on.

ANNULLING A PROGRAMME

-A programme can be cancelled by pressing the COOKING

DURATION

button and then the "-" button until the display shows

0.00.

IMPORTANT:

AT THE END OF EVERY PROGRAMMED COOKING

OPERATION YOU ARE ADVISED TO PRESS THE BUTTON,

OTHERWISE THE OVEN CANNOT BE OPERATED

MANUALLY.

FOR COOKERS WITH SELF-CLEANING OVEN

The two side walls and the back are coated with a catalytic self-

cleaning enamel.

Every 10-15 times it is used, leave the oven empty at full heat.

The time required for cleaning depends on the condition of the

oven. Some splashes tend to set hard and may clog the pores

of the special coating, preventing oxidation and eliminating its

self-cleaning properties. In this case, as soon as the oven has

completely cooled apply very hot water to soften the deposits

and use a soft brush, without detergent, to remove them. Then

switch the oven back on at maximum heat for a few minutes.

(Important: never use metal brushes or abrasive substances).

USE OF THE PAN RETAINERS (fig. 17)

To insert and extract the pan retainers lightly press in both

directions as shown in the figure below.

To lock the pan retainer in its vertical position, press downward

the two outer sides.

For the user

GENERAL PRECAUTIONS

- Always disconnect the power supply before any work inside

the oven or where live parts may be accessed.

-Never use the warming compartment for storing inflammable

liquids or items which do not withstand heat, such as wood,

paper, aerosol cans, matches, etc.

- Make frequent checks on the rubber connection hose, ensuring

that it is well away from hot surfaces, that there are no sharp

bends or kinks, and that it is in good condition. The hose must

be replaced at the latest at the indicated date and must be

secured at both ends using a standard hose clamp.

- If taps become stiff to operate over time, contact the After-

Sales service.

-Wash enamelled or chrome-plated parts with soapy lukewarm

water or non-abrasive detergents. A metal brush may be used

to remove deposits from hob burners and flame caps. Dry

thoroughly.

-Never use abrasives to clean enamelled or chrome-plated parts.

- Do not use too much water when washing the hob. Take care

that no water or other substances enter the burner housing

holes, as this may be dangerous.

- The spark plugs for electric ignition must be kept clean and

dry; always check after use, particularly if there have been drips

or overflows from pans.

-Never close glass lids until the hob burners or hotplates have

cooled completely; it might shatter or crack.

-Never knock enamelled parts or ignition spark plugs (where

present).

- The main or wall gas tap should be turned off when the cooker

is not in use.

No liability is accepted for injury or damage caused by poor

installation or improper use of the cooker.

In case of malfunctions, particularly gas leaks or short-

circuits, contact your engineer without delay.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bompani BO613 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info