Bedienungsanleitung Bora CKFI (Seite 17 von 64) (Englisch)

714388

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Appliance description

www.bora.com

4.2.2 Installation variations

Depending on what you opted for when purchasing, the

cooktop extractor can be operated as an exhaust air or an

recirculating air version.

Exhaust mode

The air suctioned away is purified by the grease filter and

expelled into the open air via a duct system.

The exhaust air must not be expelled into:



a smoke or exhaust gas flue that is in operation



a shaft used for the aeration of rooms where fireplaces

are installed.

If the exhaust air is to be directed into a smoke or

exhaust gas flue that is not in use, the installation must

be checked and approved by the responsible heating

engineer.

INFO If the cooktop extractor is used in an exhaust

air system, the extractor power is automatically

increased for the first 20 seconds when set on a

lower power level (wall sleeve function).

Recirculation mode

The air suctioned away is purified by the grease filter and

an activated carbon filter and fed back into the room in

which the appliance is installed.

To prevent odours in recirculation mode, an odour filter

must be used. For hygiene and health reasons, this must

be replaced at the recommended intervals (see the

Cleaning and maintenance chapter).

INFO In recirculation mode, ensure sufficient ventilation

and aeration to expel humidity.

INFO If the cooktop extractor is used in a recirculating

air system, when a power level is set the

operating time is automatically deducted from the

recirculation filter service life. The remaining filter

service life can be seen in the menu under menu

item A (see Operation chapter).

Example:

Fig. 4.4 Operating panel lighting

[1] Active and selectable function (brightly lit, 75%)

[2] Inactive but selectable function (dimmed, 50%)

4.1.6 Sounds

INFO The volume of the acoustic signals can be set in

the menu (10% to 100%).

INFO Safety-relevant acoustic signals are always

emitted with the volume at 100%.

The system basically differentiates between three

different types of acoustic signals:

Acoustic signal Purpose

Short individual beep (0.25 s) Confirmation of a selection

Sequence of beeps Interaction required

Long individual beep (0.75 s) End of a function

Tab. 4.5 Sounds

4.1.7 System functions

Short-time timer (egg timer)

The short-time timer emits both a visual and an acoustic

signal after a time set by the user

and offers the function of a conventional egg timer.

4.2 Cooktop extractor

INFO The cooktop extractor CKA2 is the central

component and contains all of the electronics for

operating the entire BORA Classic 2.0 system. It

is not possible to operate the system or individual

components without a cooktop extractor.

4.2.1 Model description

Model Long description

CKA2 BORA Classic cooktop extractor flexible system

with separate control unit, can be combined with

the Classic cooktops and other BORA Universal

components

Tab. 4.6 Model description

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bora CKFI Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bora CKFI

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info