Bedienungsanleitung Bora Pura (Seite 22 von 60) (Englisch)

714404

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Installation

www.bora.com

6 Installation

6.1.1 Simultaneous operation of the cooktop

extractor in the exhaust air mode and a

fireplace dependent upon the air supply

in the room

i National and regional laws and regulations must be

observed with regard to the exhaust duct design.

i A sufficient air supply must be ensured.

Fireplaces that depend on the air in the room (e.g. gas, oil,

wood or coal-fired heaters, continuous-flow water heaters,

instantaneous water heaters) draw in air from the room in which

they are installed and release the exhaust fumes into the outside

air via an exhaust system (e.g. chimney).

If the cooktop extractor is used in exhaust air mode, it draws

in air from the room in which it is installed as well as from

neighbouring rooms. If there is insufficient air supply, low

pressure will occur. Toxic gases could be drawn out of the

chimney or extraction ducting and back into the room.

Fig. 6.1 Exhaust air installation – not permitted

Fig. 6.2 Exhaust air installation – correct

XXIf simultaneously operating both a fireplace and the cooktop

extractor in the same room, ensure that:

XO the maximum low pressure is 4Pa (4 x 10–5bar);

XO a safety device (e.g. window contact switch, low pressure

warning device) is used to ensure that a sufficient supply

of fresh air is guaranteed;

XO the exhaust air is not be ducted into a chimney that is

used for exhaust gases of devices operated with gas or

other combustibles;

XO the installation is checked and approved by an authorised

certified engineer (e.g. heating engineer).

i If the cooktop extractor is used exclusively in

recirculation mode, operation with an open fireplace is

possible without any additional safety measures.

XXObserve all safety and warning information (see the “Safety”

chapter).

XXFollow the enclosed manufacturer‘s information

6.1 General installation instructions

i The power supply cable must be provided by the

customer.

i The appliance must not be installed above cooling

devices, dishwashers, stoves, ovens, washing machines

or dryers.

i The contact surface of the worktops and wall sealing

strips must be made of a heat-resistant material (up to

approx. 100 °C).

i Worktop cut-outs must be moisture-sealed using suitable

means and, where necessary, fitted with a thermal

insulator.

i The integrated cooktop extractor must not be used with

other cooktops.

General installation instructions for cooktops

i To ensure that the cooktops perform optimally at all

times, there must be sufficient ventilation beneath the

cooktops.

i The performance of the cooktops is affected or the

cooktops overheat if the warm air beneath the cooktops

cannot escape.

i If a cooktop overheats, the power is automatically

reduced or the cooktop is switched off completely (see

“Overheating protection”).

i If cable protection (false floor) is planned beneath the

appliance, this must be fitted so it does not obstruct

ventilation.

XXMake sure that the area below the cooktop has a sufficient air

supply.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bora Pura Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bora Pura

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info