Bedienungsanleitung Bora Puru (Seite 25 von 60) (Französisch)

714405

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Installation

www.bora.com

6 Installation

 Observe all safety and warning information

(see the Safety chapter).

 Follow the enclosed manufacturer‘s information

6.1 General installation information

INFO The power supply cable must be provided by the

customer.

INFO The appliance must not be installed above cooling

devices, dishwashers, stoves, ovens, washing

machines or dryers.

INFO The contact surface of the worktops and wall

sealing strips must be made of a heat-resistant

material (up to approx. 100 °C).

INFO Worktop cut-outs must be moisture-sealed using

suitable means and, where necessary, fitted with

a thermal insulator.

INFO The integrated cooktop extractor must not be

used with other cooktops.

General installation information for cooktops

INFO To ensure that the cooktops perform optimally

at all times, there must be sufficient ventilation

beneath the cooktops.

INFO The performance of the cooktops is affected or

the cooktops overheat if the warm air beneath the

cooktops cannot escape.

INFO If a cooktop overheats, the power is automatically

reduced or the cooktop is switched off completely

(see Overheating protection).

INFO If cable protection (false floor) is planned beneath

the appliance, this must be fitted so it does not

obstruct ventilation.

 Make sure that the area below the cooktop has a

sufficient air supply.

6.1.1 Simultaneous operation of the

cooktop extractor in the exhaust air

mode and a fireplace dependent upon

the air supply in the room

INFO The state and regional laws and regulations must

be observed with regard to the exhaust duct

design.

INFO A sufficient air supply must be ensured.

Fireplaces that depend on the air in the room (e.g. gas,

oil, wood or coal-fired heaters, continuous-flow water

heaters, instantaneous water heaters) draw in air from

the room in which they are installed and release the

exhaust fumes into the outside air via an exhaust system

(e.g. chimney).

If the cooktop extractor is used in exhaust mode, it draws

in air from the room in which it is installed as well as from

neighbouring rooms. If there is insufficient air supply, low

pressure will occur. Toxic gases could be drawn out of the

chimney or extraction ducting and back into the room.

Fig. 6.1 Exhaust air installation – not permitted

Fig. 6.2 Exhaust air installation – correct

 If simultaneously operating both a fireplace and the

cooktop extractor in the same room, ensure that:



the maximum low pressure is 4 Pa (4 x 10–5 bar);



a safety device (e.g. window contact switch, low

pressure warning device) is used to ensure that a

sufficient supply of fresh air is guaranteed;



the exhaust air is not be ducted into a chimney that

is used for exhaust gases of devices operated with

gas or other combustibles;



the installation is checked and approved by an

authorised certified engineer (e.g. heating

engineer).

INFO If the cooktop extractor is used exclusively in

recirculation mode, operation with an open

fireplace is possible without any additional safety

measures.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bora Puru Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bora Puru

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info