8
GB
4 OPERATION
A - EXTRACTION OR RECYCLING
Your cooker hood is supplied in the extraction mode. To use the cooker hood in the recirculation mode re-programme the hood
as follows:
Starting in the recirculation mode
Press the ‘+’ button for 10 seconds (while the motor and lights are switched ‘OFF’) and the two LED lights will flash twice to
indicate confirmation that the cooker hood is in the recycling mode.
Reverting to the extraction mode
Press the ‘+’ button for 10 seconds (while the motor and lights are switched ‘OFF’) and the two LED lights will flash once to
indicate confirmation that the cooker hood is in the extraction mode.
B – BASIC INSTRUCTIONS
Lighting
Press Button 1 to switch ‘ON’ the lights.
Motor
Press LED button 2 to switch ‘ON’ the fan motor, the LED F will illuminate to confirm the motor is switched ‘ON’, and adjust
the speed of the fan motor by pressing the Button ‘+’ and ‘-‘. The fan speed will be increased if constant pressure is kept on
the (+) button.
Press LED button 5 to obtain the boost position for maximum effect and the LED C will illuminate to confirm fan is switched
‘ON’.
C – COMPLEMENTARY INSTRUCTIONS
Automatic pre-set stop for the boost speed after 10 mn.
To obtain the best performance it is advisable to switch ‘ON’ the cooker hood a few minutes (in the boost setting) before you
start cooking and you should leave it running for approximately 10 minutes after finishing.
Press LED button 5 to switch ‘OFF’ the fan motor immediately.
Indication of saturation of the metal grease filters
After 100 hours use, one quick flash of the LED F will indicate that you must clean the metal grease filters. (See chapter on
‘Maintenance’).
This indication is not available when the fan motor is switched OFF.
Indication of saturation of the active charcoal filter
After 200 hours use, two quick flash of the LEDS F & C will indicate that you must replace the active charcoal filter and clean
