555095
17
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
17
MAINTENANCE
Empty the water from the water tank and dry body after
using the unit. Please cleaner the lter cotton in the
dustbin, cover of dustbin and under of machine, after
you are using the machine.
TROUBLE SHOOTING
If the unit does not turn on, check to see that
it is connected properly to the power source If
steam stops coming out, check to see that
there is enough water in the water tank If the vacuum
function does not work properly, check to see that the
dustbin has been cleaned and is empty and is attached
properly back into the unit.
If there is and damage to the power cord, plug or not
attempt to x the unit by yourself. Consult a quali ed
electrician to get problem xed before using the unit
again.
CAUTION: To reduce the risk of electric
shock, do not remove the hose while machine
is on.
This hose contains electrical connections:
- Do not immerse in water for cleaning;
- The hose should be checked and must not be used
if damaged.
WARNING: To prevent re or electric shock, do not
expose this equipment to rain or moisture.
USING TOUR APPLIANCE
HOW TO CLEAN WITH STEAM-STEAM-USEFUL
TIPS
To make the most of your steam cleaner the following
tips will be helpful in making cleaning tasks easier,
safer and more productive.
There are on set rules on how to clean with steam,
however the key to using your steam cleaner
successfully is to use right tool and set your body in
the best possible position to comfortably do each job.
There are many areas where steam can be used to
clean. Do not be afraid of trying something new or
attempting to clean something that you have not tried
to clean before.
If you are unsure if seam may cause damage to a
particular surface, always test a small surface rst
before attempting to clean the whole area.
4. After lling the water into the water tank, push
down and screw the steam pressure release device in
clockwise direction until the cap is screwed on tight.
After the cap appears to be on tight, double check it is
on properly by pressing the cap down and turn until the
cap is tight and cannot turn tighter.
Once the water starts heating, if you hear steam
pressurizing out of the cap , then you need turn off the
power, and take a towel, place it over the cap, press
down the cap and tighten until it won’t move anymore.
When re lling water, the unit must be disconnected
from power supply, and the steam pressure cap shall
not be opened until the water tank cools down.
Note: Even if don’t recommend it, but if you require
to re ll the tank immediately, use a towel to carefully
unscrew the cap as the cap will still be very hot.
If you do re ll the tank immediately. Be very careful
as the boiling water may splash out of the boiler and
cause potential burns to your skin.
5. Please check the water level in the dustbin, when
you want using the vacuum cleaner, and then close the
dustbin cover.
When the dustbin inhaled plenty of water or dust,
protect the device will start, at this time, you will feel no
suction power, we only need to clean up dustbin, and
then to ll (500 ml – 750 ml) minimum 500 ml water
(2 Measuring cups), close the dustbin cover, and you
can to use again.
6. Plug into a power outlet (220–240 v) and switch on
the steam or vacuum button, to use the function as
required by you.
7. To use the steam function, press the steam button to
on position and then wait for the “steam ready” light to
go on. About 8 minutes. The steam is now ready to use.
After joining the steaming (cleaning) head to the plug
of the tube, switch on the ”LOCK” button (turning it on
right) to ensure the head not to be separated from the
tube during the using.
Press the trigger on the gun and use the steam volume
adjustment knob to operate steam function as required.
Use the steam lock if continuous steam is required.
When rst using the steam, hold the steam outlet over
a sink or into a bucket as it may produce excessive
water for the for 10–20 seconds or until the steam
becomes dry. If your job requires more moisture then it
will be ok to use immediately after heating up.
8. After using the steam function for a while, the
steam pressure may weaken. If you require the steam
pressure to build up again, let go off the steam until the
ready light goes off.
9. To use the vacuum function, press the vacuum
button to on position and vacuum with the accessory
required.
10. To empty the vacuum waste tank, rst switch off
the steam and vacuum buttons and unplug the unit.
Open the cover and pull out the dustbin b by using the
handle. Empty and clean the dustbin, push back into
place and close the cover.
11. Before attaching any accessory to the unit or the
steam gun, make sure the steam is off.
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

bort-bss-3500-st

Suche zurücksetzen

  • Wie komme ich an eine deutsche Bedienungsanleitung Eingereicht am 2-7-2017 11:15

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bort BSS-3500-St wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info