97284
17
Zoom out
Zoom in
Vorherige Seite
1/126
Nächste Seite
English | 173 609 929 A78 8.8.06
Noise/Vibration Information
Measured sound values determined in accordance with
EN ISO 15744.
Measured vibration values determined in accordance
with EN 28662 and EN ISO 8662.
Typically the A-weighted noise levels of the tool are:
sound pressure level 80 dB(A); sound power level
93 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
The hand-arm acceleration is typically below 2.5 m/s
2
.
Uncertainty K=1.2 m/s
2
.
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or stan-
dardization documents: EN 792, according to the
provisions of the directive 98/37/EC.
03.08.2006, Robert BoschGmbH, Power Tools Division
D-70745 Leinfelden Echterdingen
Technical Data
Assembly
Suspension and clamping device
f If you wish to operate the pneumatic tool in a
suspension or clamping device, make sure
that the pneumatic tool is first mounted in the
device before you connect it to the air supply.
In this way you avoid starting the tool accidentally.
You can use the clamping area 10 to mount the pneu-
matic tool in a clamping device. If possible, use the
entire clamping area. The smaller the clamping area,
the stronger the clamping force.
Do not overstrain the clamping area and make sure that
the clamping device holds the tool securely and tightly.
With the hanging hoop 4, the pneumatic tool can be
attached to a suspension device.
f Regularly check the condition of the hanging
hoop and the hook of the suspension device.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
Pneumatic Angle Nutrunner with Shut-off Mechanism
Article number 0 607 452 603 0 607 452 604 0 607 452 605
No-load speed n
0
rpm 570 400 320
Output power W
Hp
550
0.74
550
0.74
550
0.74
Max. torque for hard/soft screwdriving
application according to ISO 5393
Nm
ft-lbs
1640*
11.829.5*
1656*
11.841.3*
2068*
14.750.1*
Max. screw dia. mm M6 M8 M8
Rotational direction
Tool holder 3/8" 3/8" 3/8"
Lever start zzz
Shut-off clutch z z z
Rated pressure bar
psi
6.3
91
6.3
91
6.3
91
Connecting thread G1/4" G1/4" G1/4"
Inside hose diameter mm
in
10
3/8"
10
3/8"
10
3/8"
Air consumption under load l/s
cfm
15
31.8
15
31.8
15
31.8
Weight according to
EPTA-Procedure 01/2003
kg
lbs
1.50
3.30
1.50
3.30
1.50
3.30
* When the tool is used in the upper torque range, it must be supported by using a reaction bar.
OBJ_BUCH-220-001.book Page 17 Tuesday, August 8, 2006 9:41 AM
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

bosch-0-607-452-603

Suche zurücksetzen

  • Ich kann die Kindersicherung nicht rückgängig machen
    Eingereicht am 21-7-2022 13:54

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch 0 607 452 603 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info