Bedienungsanleitung Bosch AdvancedAquatak 140 (Seite 19 von 294) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

707726

Zoom out

Zoom in

Vorherige Seite

1/294

Nächste Seite

English | 19

Problem Possible Cause Corrective Action

Fuses blow Fuses incorrectly rated Change to a mains supply higher than the pres-

sure washer amp consumption

Motor starts but no

pressure

Nozzle partly blocked Clean nozzle

Motor “sounds” but

fails to start

Insufficient power supply Check that the voltage of the mains power supply

line is the same as that on the plate.

Voltage loss due to use of extension cable Check characteristics of extension cable

Appliance not used for a long period of time Contact your Bosch Service Centre

Problems with TSS (Total Stop System) device Contact your Bosch Service Centre

Pressure pulsating Air in the inlet water supply hose/pump Allow pressure washer to run with open spray

handle and nozzle at low pressure until regular

working pressure is obtained

Inadequate water supply Check that the water supply corresponds to spe-

cifications. The minimum specification for the wa-

ter supply hose is 1/2" or 13mm diameter

Water filter blocked Clean water filter

Water supply hoses squeezed Straighten out kinked water supply hoses

High pressure hose too long Remove high pressure extension hose. Retry (ex-

tension hose max. 7m)

Pressure too low, but

steady

Note: Several types of

accessory will normally

deliver a lower pres-

sure

Nozzle worn Change the nozzle

Start/stop valve worn Activate trigger five times in quick succession

Motor starts up but

with restricted or no

working pressure

No water supply Connect water supply

Water filter clogged up Clean the water filter

Nozzle clogged up Clean nozzle

The pressure washer

starts irregularly by it-

self

Pump/ power gun leaky Contact your Bosch Service Centre

Water leaks from ma-

chine

Leaking pump A slight water leak is permissible; in case of ex-

cessive leak, contact Bosch Service Centre.

Maintenance and Service

Maintenance

u Stop, remove plug from the power supply and discon-

nect from water supply.

Note: To ensure long and reliable service, carry out the fol-

lowing maintenance regularly.

Regularly check for obvious defects such as loose fixings,

and worn or damaged components.

Check that covers and guards are undamaged and correctly

fitted. Carry out necessary maintenance or repairs before

using.

In order to avoid safety hazards, if the power supply cord

needs to be replaced, this must be done by Bosch or by an

after-sales service centre that is authorised to repair Bosch

power tools.

After use/Storage

Turn the main switch off and operate the trigger to drain the

water from the high pressure hose.

Clean the exterior of the machine thoroughly using a soft

brush or cloth. Do not use water, solvents or polishes. Re-

move all debris, especially from the ventilation slots.

End of season storage: Drain water out of pump running mo-

tor for a few seconds. Pull trigger to release all water.

Do not place other objects on top of the machine.

Store in a frost-free area.

Ensure cables are not trapped when storing. Do not kink high

pressure hose.

After-sales Service and Application Service

www.bosch-do-it.com

Bosch Power Tools F 016 L81 693 | (30.04.2019)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch AdvancedAquatak 140 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info