Bedienungsanleitung Bosch AHS 48 LI (Seite 16 von 237) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

537936

Zoom out

Zoom in

Vorherige Seite

1/237

Nächste Seite

16 | English

F 016 L81 044 | (5.2.14) Bosch Power Tools

Battery Charging

 Do not use other battery chargers. The supplied battery

charger is designed for the Lithium-Ion battery in your gar-

den product.

 Observe the mains voltage! The voltage of the power

supply must correspond with the data given on the name-

plate of the battery charger. Battery chargers marked with

230 V can also be operated with 220 V.

The battery is equipped with temperature monitoring that al-

lows charging only in the temperature range between 0 °C

and 45 °C. In this manner, a high battery service life is

achieved.

Note: The battery is supplied partially charged. To ensure full

capacity of the battery, completely charge the battery in the

battery charger before using your power tool for the first time.

The lithium ion battery can be charged at any time without re-

ducing its service life. Interrupting the charging procedure

does not damage the battery.

The “Electronic Cell Protection (ECP)” protects the lithium ion

battery against deep discharging. When the battery is run

down or discharged, the garden product is shut off by means

of a protective circuit: The garden product no longer operates.

Do not continue to press the On/Off

switch after the garden product has

been automatically switched off. The battery can be dam-

aged.

Charging Procedure

The charging procedure starts as soon as the mains plug is

plugged into the socket and the battery is then inserted into

the battery charger .

Firstly, place the battery as shown in the figure onto the front

of the battery charger () and then press the battery down

at the rear (). To remove the battery, proceed in reverse or-

der.

Due to the intelligent charging method, the charging condi-

tion of the battery is automatically detected and the battery is

charged with the optimum charging current, depending on

battery temperature and voltage.

This gives longer life to the battery and always leaves it fully

charged when kept in the charger for storage.

Note: The charging procedure is only possible when the bat-

tery temperature is within the allowable charging tempera-

ture range, see section “Technical Data”.

Flashing Battery Charge Indicator

The charging procedure is signalled by a

flashing battery charge indicator .

Continuous Lighting of the Battery Charge Indica-

tor

Continuous lighting of the battery

charge indicator indicates that the

battery is fully charged or that the

temperature of the battery is not with-

in the allowable charging temperature range, and cannot be

charged for this reason. The battery is charged as soon as the

allowable charging temperature range is reached.

When the battery is not inserted, continuous lighting of the

battery charge indicator indicates that the mains plug is in-

serted in the socket and that the battery charger is ready for

operation.

Charging Advice

With continuous or several repetitive charging cycles without

interruption, the charger can warm up. This is not meaningful

and does not indicate a technical defect of the battery charger.

A significantly reduced working period after charging indi-

cates that the battery is used and must be replaced.

Observe the notes for disposal.

Anti Blocking

The garden product has a patented feature which works as

follows:

If the blade stalls on a tough material, the load of the motor in-

creases. The intelligent micro-electronics senses this over-

load condition and repeatedly reverses the motor, in order to

prevent stalling and to cut the material through.

This audible reversing cut action continues for up to 3 s.

After cutting through, the garden product continues in its nor-

mal mode, or in case the overload condition continues the

blades automatically stop in the open position (e. g. in case a

piece of metal fence accidentally blocks the garden product).

Troubleshooting

The following chart lists problem symptoms, possible causes and corrective action, if your garden product does not operate

properly. If these do not identify and correct the problem, contact your service agent.

 Warning: Switch off and remove the battery prior to any troubleshooting.

Problem Possible Cause Corrective Action

Hedgecutter does not op-

erate

Battery discharged Recharge battery; also see “Battery Charging”

Safety switch not activated correctly see “Initial Operation”

Hedgecutter operates in-

termittently

Internal wiring of garden product damaged Contact Service Agent

On/Off switch defective Contact Service Agent

Motor reverses repeatedly then stalls after 3 s. see “Working Advice” (Anti Blocking)

OBJ_DOKU-37685-002.fm Page 16 Wednesday, February 5, 2014 1:08 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch AHS 48 LI Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info