697455
144
Zoom out
Zoom in
Vorherige Seite
1/158
Nächste Seite
All keyfob configuration are correct and fault is reset.
Supervise:
1. Slow flash FAULT indicator (refer to Keypad Indicators for the detailed description).
2. When the fault is reset, the FAULT indicator is turned off when there is no other system
fault.
2 - Power Failure
The zone indicator 2 lights to indicate power faults. Enter [2] to step to power faults list for
more information.
Panel AC Failure
Condition:
1. AC supply deficiency to panel caused by transformer.
2. Power supply fuse broken (230V).
3. Power supply disconnected (230V).
Restore:
1. AC MAINS supply is reconnected and fault is reset.
2. Monitor the voltage by MPU.
3. f the AC fault is not restored in 1 hour after the fault occurred, report the fault to
configured destination on address 124.
4. Slow flash FAULT indicator (refer to Keypad Indicators for the detailed description).
5. As the AC supply is reconnected, the MAINS indicator is back to light (except in
Programming Mode or Code Functions Mode).
6. When the fault is reset, send the restored report to the configured destinations.
Battery Low Battery
Condition:
1. Battery voltage is lower than 11V+-1%.
2. No battery connected.
Restore:
When Battery voltage rises to 12V+-1%, Dynamic Battery test is performed (time set in
Programming address 204), and fault is reset.
Supervise:
1. The system performs a Dynamic Battery Test every time (set in address 204) and every
time the system is armed or reset.
2. Report the low battery to the configured destination programmed on address 124.
3. Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
4. When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Panel Aux Power Failure
Condition:
Aux Power Supply Voltage is lower than 9V.
Restore:
Voltage is raised to 12 and fault is reset.
Supervise:
1. Monitor the voltage by MPU.
2. Report the AUX power fault to the configured destination programmed on address 124.
3. Slow flash FAULT indicator (refer to Keypad Indicators for the detailed description).
144
en | Troubleshooting AMAX 2100 / 3000 / 4000
2013.10 | 01 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH
144

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch AMAX 2100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bosch AMAX 2100

Bosch AMAX 2100 Installationsanweisung - Deutsch - 170 seiten

Bosch AMAX 2100 Kurzanleitung - Deutsch - 34 seiten

Bosch AMAX 2100 Bedienungsanleitung - Englisch - 24 seiten

Bosch AMAX 2100 Bedienungsanleitung - Englisch - 36 seiten

Bosch AMAX 2100 Kurzanleitung - Englisch - 38 seiten

Bosch AMAX 2100 Installationsanweisung - Holländisch - 166 seiten

Bosch AMAX 2100 Bedienungsanleitung - Holländisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info