697454
157
Zoom out
Zoom in
Vorherige Seite
1/170
Nächste Seite
AMAX panel Troubleshooting | en 157
Bosch Security Systems B.V. Installation Manual 2019.08 | 11 | F.01U.309.277
1. Reconnect the AC supply and reset the fault. For more information refer to Installation,
page 23.
2. Monitor the voltage by MPU.
Supervise:
1. If the AC supply is not restored one hour after the fault occurred, report the fault to
configured destination on address 124.
Slow flash FAULT indicator (refer to Keypad indicators, page 8 for a detailed description).
When the AC supply is reconnected, the MAINS indicator lights up (except in
programming mode or in code functions mode).
2. When the fault is reset, send the restored report to the configured destinations.
P The FAULT indicator is turned off when there is no other system fault.
Battery Low Battery
Condition:
1. The battery voltage is lower than 11V+-1%.
2. No battery is connected.
Restore:
1. Connect a battery. For more information, refer to Battery installation, page 24.
2. Raise battery voltage to 12V+-1%, perform a dynamic battery test (time set in
programming address 204) and reset the fault.
Supervise:
1. Set the system to perform a dynamic battery test on a regular basis (time set in
programming address 204) and every time the system is armed or reset.
2. Report the low battery to the configured destination programmed on address 124.
Slow flash FAULT indicator (refer to Keypad indicators, page 8 for a detailed description).
3. When the fault is reset, send the restored report to the configured destinations.
P The FAULT indicator is turned off when there is no other system fault.
Panel Aux Power 1-2 Failure
Condition:
The Aux power supply voltage is lower than 9V.
Restore:
4 Raise the voltage to 12V and reset the fault.
Supervise:
1. Monitor the voltage by MPU.
2. Report the AUX power fault to the configured destination programmed on address 124.
Slow flash FAULT indicator (refer to Keypad indicators, page 8 for a detailed description).
3. When the fault is reset, send the restored report to the configured destinations.
P The FAULT indicator is turned off when there is no other system fault.
Bosch Option Bus Power 1-2 Failure
Condition:
Bosch option bus power supply voltage is lower than 9V+-5%.
Restore:
4 Raise the voltage to 12V and reset the fault. For more information refer to Bosch option
bus, page 13.
Supervise:
1. Monitor the voltage by MPU.
157

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch AMAX panel 4000 EN wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bosch AMAX panel 4000 EN

Bosch AMAX panel 4000 EN Kurzanleitung - Deutsch - 76 seiten

Bosch AMAX panel 4000 EN Kurzanleitung - Holländisch - 76 seiten

Bosch AMAX panel 4000 EN Installationsanweisung - Holländisch - 190 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info