Bedienungsanleitung Bosch BEL523MS0B (Seite 16 von 24) (Englisch)

746696

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

en Trouble shooting

3Trouble shooting

Tr oubl e shoot i ng

If a fault occurs, there is often a simple explanation.

Before calling the after-sales service, please refer to the

fault table and attempt to correct the fault yourself.

Tip: If a dish does not turn out exactly as you wanted,

refer to the following chapter, where you will find lots of

tips and notes relating to the optimum

settings.~ "Tested for you in our cooking studio"

on page 18

:Warning – Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be

carried out and damaged power cables replaced by

one of our trained after-sales technicians. If the

appliance is defective, unplug the appliance from the

mains or switch off the circuit breaker in the fuse box.

Contact the after-sales service.

Fault table

--------

Fault Possible cause Remedy/information

The appliance is not working The plug is not plugged into the mains Connect the appliance to the electricity supply

Power failure Check whether other kitchen appliances are working

The circuit breaker/fuse is faulty Check in the fuse box to make sure that the circuit

breaker/fuse for the appliance is in working order

Faulty operation Switch off the circuit breaker/fuse for the appliance in

the fuse box and switch it back on after approximately

10 seconds

Three zeros are lit on the display. Power failure Reset the time.

The appliance is not operating. A

cooking time is shown on the display.

The rotary selector has been accidentally turned. Press the "stop" button.

The "start" button has not been pressed after the set-

ting was applied.

Press the "start" button or cancel the setting by press-

ing the "stop" button.

The microwave is not working. The door has not been properly closed. Check whether food remnants or debris is/are

trapped in the door.

The "start" button has not been pressed. Press the "start" button.

It is taking longer than usual for food

to heat up

The microwave power output has been set too low. Select a higher microwave power setting.

A larger amount of food than usual has been placed in

the appliance.

Double the amount – double the time.

The food was colder than usual. Stir or turn the food during heating.

The turntable is making a scraping or

grinding noise.

Dirt or debris in the area around the turntable drive. Clean the roller ring and the recess in the cooking

compartment.

The microwave has stopped for no

apparent reason.

The microwave has a fault. If this fault recurs, please call the after-sales service.

An i is shown on the display.

The appliance is in demo mode Deactivate demo mode.

~ "Basic settings" on page 14

Error message "E - 3" Fault in automatic door opening system. If an error message is displayed, switch the appliance

off and on again; if the message disappears, it was a

one-off problem. If the fault occurs again or the error

message is still displayed, please contact the after-

sales service and provide the fault code.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch BEL523MS0B Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info