Bedienungsanleitung Bosch BEL554MS0B (Seite 17 von 24) (Englisch)

746687

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

en Trouble shooting

3Trouble shooting

Tr oubl e s hoot i ng

If a fault occurs, there is often a simple explanation.

Before calling the after-sales service, please refer to the

fault table and attempt to correct the fault yourself.

Tip: If a dish does not turn out exactly as you wanted,

refer to the following chapter, where you will find lots of

tips and notes relating to the optimum

settings.~ "Tested for you in our cooking studio"

on page 18

:Warning – Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be

carried out and damaged power cables replaced by

one of our trained after-sales technicians. If the

appliance is defective, unplug the appliance from the

mains or switch off the circuit breaker in the fuse box.

Contact the after-sales service.

Fault table

--------

Fault Possible cause Remedy/information

The appliance is not working The plug is not plugged into the mains Connect the appliance to the electricity supply

Power failure Check whether other kitchen appliances are working

The circuit breaker/fuse is faulty Check in the fuse box to make sure that the circuit

breaker/fuse for the appliance is in working order

Faulty operation Switch off the circuit breaker/fuse for the appliance in

the fuse box and switch it back on after approximately

10 seconds

Three zeros are lit on the display. Power failure Reset the time.

The appliance is not operating. A

cooking time is shown on the display.

The rotary selector has been accidentally turned. Press the "stop" button.

The "start" button has not been pressed after the set-

ting was applied.

Press the "start" button or cancel the setting by press-

ing the "stop" button.

The microwave is not working. The door has not been properly closed. Check whether food remnants or debris is/are

trapped in the door.

The "start" button has not been pressed. Press the "start" button.

It is taking longer than usual for food

to heat up

The microwave power output has been set too low. Select a higher microwave power setting.

A larger amount of food than usual has been placed in

the appliance.

Double the amount – double the time.

The food was colder than usual. Stir or turn the food during heating.

The turntable is making a scraping or

grinding noise.

Dirt or debris in the area around the turntable drive. Clean the roller ring and the recess in the cooking

compartment.

The microwave has stopped for no

apparent reason.

The microwave has a fault. If this fault recurs, please call the after-sales service.

i is shown on the display.

The appliance is in demo mode Deactivate demo mode.

~ "Basic settings" on page 14

Error message "E - 3" Fault in automatic door opening system. If an error message is displayed, switch the appliance

off and on again; if the message disappears, it was a

one-off problem. If the fault occurs again or the error

message is still displayed, please contact the after-

sales service and provide the fault code.

Customer service en

4Customer service

Cus t omer ser vi ce

Our after-sales service is there for you if your appliance

needs to be repaired. We will always find an

appropriate solution, also in order to avoid after-sales

personnel having to make unnecessary visits.

E number and FD number

When calling us, please quote the full product number

(E no.) and the production number (FD no.) so that we

can provide you with the correct advice. The rating plate

bearing these numbers can be found on the right-hand

side when you open the cooking compartment door.

To save time, you can make a note of the numbers for

your appliance and the telephone number of the after-

sales service in the space below in case you need

them.

Please note that a visit from an after-sales service

engineer is not free of charge in the event that the

appliance has been misused, even during the warranty

period.

Please find the contact data of all countries in the

enclosed customer service list.

To book an engineer visit and product advice

Rely on the professionalism of the manufacturer. You

can therefore be sure that the repair is carried out by

trained service technicians who carry original spare

parts for your appliances.

This appliance corresponds to the standards EN 55011

and CISPR 11. It is a Group 2, Class B product.

Group 2 means that microwaves are produced for the

purpose of heating food. Class B states that the

appliance is suitable for private households.

Technical specifications

E no.

FD no.

After-sales service O

GB 0344 892 8979

Calls charged at local or mobile rate.

IE 01450 2655

0.03 € per minute at peak. Off peak 0.0088 €

per minute.

=1U)'(1U

7\SH

Input voltage 230-240 V AC, 50 Hz

Power consumption 1450 W

Max. output power 900 W (IEC 60705)

Max. grill output power 1200 W

Microwave frequency 2450 MHz

Circuit breaker/fuse rating 10 A

Dimensions (H/W/D)

- Appliance 382 x 594 x 388 mm

- Cooking compartment 208 x 328 x 369 mm

VDE approved Yes

CE mark Yes

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch BEL554MS0B Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch BEL554MS0B

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info