en
Using the dust collector
Figure
Set the power setting to maximum for the
best results when vacuuming.
We recommend that you reduce the setting
only when vacuuming very delicate materials.
Emptying the dust collector
To achieve an optimal result when vacuuming,
the dust collector should be emptied each time
the vacuum cleaner is used.
Figure
Open the vacuum cleaner lid by moving the
locking lever in the direction of the arrow.
Figure
Ⅲ Pull out the dust collector carrying handle in
the direction of the arrow.
Ⅲ Remove the dust collector from the vacuum
cleaner using the carrying handle.
Figure
Ⅲ Open the base and empty the dust collector
by pressing the lid lock in the direction of the
arrow.
Ⅲ If the base is very dirty (thick dirt), clean this
first, e.g. by vacuuming it with the crevice
nozzle.
(You must fit the dust bag in the vacuum
cleaner when you do this - see Figure 29)
Ⅲ Close the base.
Figure
Refit the dust collector to the vacuum cleaner,
push in the carrying handle and close the lid.
!
Caution: The inside of the dirt collector
may become scratched with use and start
to look opaque. This does not, however,
affect the performance of the vacuum
cleaner in any way, i.e. it will continue to
function as normal.
21
20
19
18
17
Cleaning the permanent filters and
microfilters
The filters must be cleaned:
Ⅲ After any operating malfunctions, i.e. after a
blockage is cleared.
Ⅲ At least every six months.
Figure
Ⅲ Unlock the filter holder by pressing the two
lugs in the direction of the arrow and open it.
Figure
Ⅲ
Remove the microfilter and permanent filter
and wash them by hand.
!
Caution: After they have been washed by
hand, the permanent filter and the white
fleece filter should be allowed to dry for
approximately 24 hours before being used
again.
Blockages
Removing a blockage in the dust collector.
Figure
Ⅲ Unfasten the 4 snaplocks by pushing them in
the direction of the arrow and remove the
dust collector lid. Loosen the blockage, e.g.
with a screwdriver, and tap or vacuum it out.
(You must fit a dust bag in the vacuum
cleaner before vacuuming it out - see
Figure 29)
Figure
Ⅲ Replace the dust collector lid and push in the
direction of the arrow until you hear the
4 snaplocks lock into place.
!
Caution: The micro- and permanent filters
must be cleaned following any operating
problem (see Figure 22 and 23).
25
24
23
22
