Bedienungsanleitung Bosch BSG 62001 (Seite 14 von 101) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

76427

Zoom out

Zoom in

Vorherige Seite

1/101

Nächste Seite

Figure

You can use the parking aid on the side of the vacuum

cleaner if you wish to stop vacuuming for a short time.

Once you have switched off the vacuum cleaner, slide the

catch on the floor tool into the groove on the side of the

appliance.

Figure

The appliance can also be carried using one of the two

handles when vacuuming steps, for example.

When the work is done

Figure

Unplug the vacuum cleaner.

Tug the power cord briefly and let go. The cable then

rewinds automatically.

Figure

To store or transport the vacuum cleaner, use the storage

aid on the underside of the vacuum cleaner.

Stand the vacuum cleaner up on its end. Slide the catch on

the floor tool into the groove on the underside of the

appliance.

Changing the dust bag

Replacing the dust bag

Figure

a) If the dust bag change indicator is completely yellow when

the floor tool is lifted from the floor and the highest suction

power is selected, the dust bag must be changed. In this

case it is essential to change the dust bag due to the type of

material it contains.

The nozzle, suction pipe and flexible tube

must not be blocked, as this would also cause the dust bag

change indicator to be triggered.

b) The handle can easily be detached from the hose to remove

blockages.

Figure

Open the lid by moving the locking lever in the direction of

the arrow.

Figure

a) Seal the dust bag by pulling the sealing strip and then

remove it.

b) Slide the new dust bag into the holder to the stop.

Caution: The lid only closes with a dust bag inserted.

Cleaning the motor protection filter

The motor protection filter should be cleaned regularly by

knocking out the dirt and rinsing.

Figure

Ⅲ

Open the dust bag compartment lid (see Figure 20).

Ⅲ

Pull out the motor protection filter in the direction of the

arrow.

19*

Ⅲ

Clean the motor protection filter by tapping it.

Ⅲ

If it is very dirty, the motor protection filter should be rinsed.

The filter must then be left to dry for at least 24 hours.

Ⅲ

After cleaning, slide the motor protection filter into the

vacuum cleaner and close the dust bag compartment lid.

Replacing the micro-hygiene filter

The motor protection filter should be changed: when starting a

newpack of bags

Figure

Ⅲ

Open the dust bag compartment lid (see Figure 20).

Ⅲ

Release the filter holder by moving the locking lever in the

direction of the arrow.

Ⅲ

Remove the micro-hygiene filter. Insert the new micro-

hygiene filter into the vacuum cleaner.

Ⅲ

Reinsert the filter holder and clip into place.

Replacing the micro active carbon filter

If your vacuum cleaner is equipped with a micro active carbon

filter, this should be replaced every six months.

Figure

Ⅲ

Open the dust bag compartment lid (see Figure 20).

Ⅲ

Release the filter holder by moving the locking lever in the

direction of the arrow.

Ⅲ

Remove the micro active-carbon filter.

Ⅲ

Insert the new micro-active carbon filter.

Ⅲ

Reinsert the filter holder and clip into place.

Replacing the Hepa filter

If your vacuum cleaner is equipped with a Hepa filter, this

should be replaced once a year.

Figure

Ⅲ

Open the dust bag compartment lid (see Figure 20).

Ⅲ

Release the Hepa filter by moving the locking lever in the

direction of the arrow and remove it from the vacuum

cleaner.

Ⅲ

Insert the new Hepa filter and clip into place.

If you have used the vacuum cleaner for fine dust particles,

clean the motor protection filter and, if necessary, replace the

micro active carbon filter or Hepa filter.

Care

Always switch off the vacuum cleaner and disconnect the

power cord from the mains before cleaning the appliance. The

vacuum cleaner and plastic accessories can be cleaned with a

commercial plastic cleaner.

Do not use a scourer, glass-cleaning agent or all-

purpose cleaning product. Never immerse the vacuum

cleaner in water.

The dust compartment can, if necessary, be cleaned with a

second vacuum cleaner or simply wiped with a a dry cloth or

dusting brush.

Subject to technical modifications.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch BSG 62001 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info