Bedienungsanleitung Bosch BSG 82022 (Seite 13 von 138) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

73286

Zoom out

Zoom in

Vorherige Seite

1/138

Nächste Seite

When the work is done

Figure

Ⅲ

Switch the vacuum cleaner off and unplug the power

cord from the mains.

Ⅲ

Tug the power cord and let go. The cable then rewinds

automatically.

Ⅲ

To reactivate or deactivate the cable brake, quickly tug

the power cord.

Figure

To store or transport the vacuum cleaner, use the storage

aid on the underside of the vacuum cleaner. Stand the

vacuum cleaner up on its end. Slide the plastic lug on the

floor tool into the groove on the underside of the unit.

Changing the dust bag and filters

Replacing the MEGAfilt

SuperTEX dust bag

Figure

Ⅲ

If the dust bag change indicator lights up brightly and

evenly when the floor tool is lifted from the carpet and

the highest suction power is selected, the dust bag must

be changed, even though it may not yet be full. In this

case it is essential to change the dust bag due to the

type of material it contains.

Ⅲ

Open the dust bag compartment lid by moving the dust

compartment locking lever in the direction of the arrow.

Figure

Seal the MEGAfilt

SuperTEX dust bag by pulling the self-

seal tap and then remove it.

Figure

Insert a new MEGAfilt

SuperTEX dust bag into the holder

and close the dust bag compartment lid.

Caution: the dust bag compartment lid will

only close

when the MEGAfilt

SuperTEX disposable or textile

filter are inserted.

If the dust bag change indicator is still lit after the

dust bag has been changed, please check whether

the nozzle, tube or flexible hose are blocked.

Figure

Mattress nozzle

For vacuuming mattresses, upholstery etc.

(attach to handle or suction pipe as required).

Figure

Pet hair upholstery nozzle

Ⅲ

For easy and thorough removal of pet hair (attach to

handle or suction pipe as required).

Ⅲ

To clean the pet hair upholstery nozzle, simply vacuum

using the handle.

Ⅲ

If it is very dirty, the pet hair upholstery nozzle can also

be opened.

To do this, turn the two screws on the sides of the nozzle

(e.g. using a coin) and remove the inner part from the

nozzle.

Ⅲ

After cleaning, replace the inner part (make sure it is

correctly seated) and screw to the housing.

Figure

Pet hair tool

Floor tool for easy and thorough vacuuming of pet hair.

Push the telescopic tube into the connecting piece of the

pet hair tool until it engages.

Press on the locking collar and pull out the telescopic

tube to disconnect.

To clean, simply vacuum the tool using the suction

pipe/handle.

Figure

Hard-floor brush

For vacuuming hard floor coverings (tiles, parquet floor-

ing, etc.)

Push the telescopic tube into the connecting piece of

the hard-floor brush until it engages.

Press on the unlatching sleeve and pull out the telescop-

ic tube to disconnect.

Figure

You can use the parking aid on the back of the vacuum

cleaner if you wish to stop vacuuming for a short time.

Slide the plastic lug on the tool connector into the

groove at the back of the vacuum cleaner.

13*

12*

11*

10*

Dependent on model

Innenteil 358 918 A 19.03.2008 8:07 Uhr Seite 11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch BSG 82022 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info