Bedienungsanleitung Bosch DIB97JP50 (Seite 15 von 20) (Englisch)

746517

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

en Installation instructions

INSTALLATION INSTRUCTIONS

I ns t al l at i on i nst r uct i ons

Installation instructions

■ This appliance is fitted to the kitchen ceiling or a

sturdy suspended ceiling.

■ Check the position of the screws using the enclosed

template.

■ Follow the enclosed installation instructions for

additional special accessories (e.g. for circulating-air

mode).

■ The surfaces of the appliance are sensitive. Avoid

damaging them during installation.

(Important safety

information

Impor t ant saf et y i nf or mat i on

Read these instructions carefully. Only then

will you be able to operate your appliance

safely and correctly. Retain the instruction

manual and installation instructions for future

use or for subsequent owners.

Check the appliance for damage after

unpacking it. Do not connect the appliance if it

has been damaged in transport.

The appliance can only be used safely if it is

correctly installed according to the safety

instructions. The installer is responsible for

ensuring that the appliance works perfectly at

its installation location.

The surfaces of the appliance are easily

damaged. Avoid damaging them during

installation.

The width of the extractor hood must

correspond at least with the width of the hob.

For the installation, observe the currently valid

building regulations and the regulations of the

local electricity and gas suppliers.

:Warning – Risk of fire!

■ Fatty deposits in the grease filter may catch

fire. The specified safety clearances must

be complied with in order to prevent a build-

up of heat. Refer to the information

provided for your cooker. If gas and electric

hobs are being operated together, the

largest specified clearance applies.

Risk of fire!

■ Grease deposits in the grease filter may

catch fire. Never work with naked flames

close to the appliance (e.g. flambéing). Do

not install the appliance near a heat-

producing appliance for solid fuel (e.g.

wood or coal) unless a closed, non-

removable cover is available. There must

be no flying sparks.

When conveying the exhaust air, official and

legal regulations (e.g. state building

regulations) must be followed.

PP

HOHFWUR JD]

PP

[

[

[ [

[

[[

[

[

[

Important safety information en

:Warning – Risk of death!

Risk of poisoning from flue gases that are

drawn back in. The exhaust air must not be

conveyed into a functioning smoke or exhaust

gas flue or into a shaft which is used to

ventilate installation rooms that contain

heating appliances. If the exhaust air is to be

conveyed into a non-functioning smoke or

exhaust gas flue, you must obtain the consent

of the heating engineer responsible.

:Warning – Danger of death!

Risk of poisoning from flue gases that are

drawn back in.

Always ensure adequate fresh air in the room

if the appliance is being operated in exhaust

air mode at the same time as room air-

dependent heat-producing appliance is being

operated.

Room air-dependent heat-producing

appliances (e.g. gas, oil, wood or coal-

operated heaters, continuous flow heaters or

water heaters) obtain combustion air from the

room in which they are installed and discharge

the exhaust gases into the open air through an

exhaust gas system (e.g. a chimney).

In combination with an activated vapour

extractor hood, room air is extracted from the

kitchen and neighbouring rooms - a partial

vacuum is produced if not enough fresh air is

supplied. Toxic gases from the chimney or the

extraction shaft are sucked back into the living

space.

■ Adequate incoming air must therefore

always be ensured.

■ An incoming/exhaust air wall box alone will

not ensure compliance with the limit.

Safe operation is possible only when the

partial vacuum in the place where the heat-

producing appliance is installed does not

exceed 4 Pa (0.04 mbar). This can be

achieved when the air needed for combustion

is able to enter through openings that cannot

be sealed, for example in doors, windows,

incoming/exhaust air wall boxes or by other

technical means.

In any case, consult your responsible Master

Chimney Sweep. He is able to assess the

house's entire ventilation setup and will

suggest the suitable ventilation measures to

you.

Unrestricted operation is possible if the vapour

extractor hood is operated exclusively in the

circulating-air mode.

:Warning – Danger of death!

Risk of poisoning from flue gases that are

drawn back in. If installing a ventilation system

in a room with a heat-producing appliance

connected to a chimney/flue, the electricity

supply to the hood must be equipped with a

suitable safety switch.

:Warning – Risk of injury!

■ Components inside the appliance may have

sharp edges. Wear protective gloves.

Risk of injury!

■ The appliance may fall down if it has not

been properly fastened in place. All

fastening components must be fixed firmly

and securely.

Risk of injury!

■ The appliance is heavy. To move the

appliance, 2 people are required. Use only

suitable tools and equipment.

Risk of injury!

■ Changes to the electrical or mechanical

assembly are dangerous and may lead to

malfunctions. Do not make any changes to

the electrical or mechanical assembly.

Bosch DIB97JP50 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch DIB97JP50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info