Bedienungsanleitung Bosch DID106G20 (Seite 8 von 12) (Englisch)

746964

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

2. Open the locking mechanism on the metal grease filter and

remove the filter from the holder.

Notes

■ When you do this, take hold of the metal grease filter from

underneath with your other hand. Make sure that the metal

grease filter does not fall and damage the hob.

■ Fat may collect in the bottom of the filter holder. Hold the

filter holder at an angle to prevent fat from dripping out.

■ Do not remove the cover plate from the inside of the

appliance.

3. Remove the activated charcoal filter from the metal grease

filter.

4. Clean the metal grease filter and the filter cover.

5. After removing the filters, clean the inside of the appliance.

Replacing or regenerating the activated charcoal filters

Activated charcoal filters trap the odour-causing compounds in

cooking smells. They are only used for circulating-air mode.

Notes

■ The activated charcoal filters are included with the appliance.

When the activated charcoal filters need to be replaced, they

can be obtained from specialist retailers, from our after-sales

service or from our online shop.

■ Only use genuine replacement filters. This will ensure that the

appliance performs optimally.

1. Remove the holder on the rear of the metal grease filter and

take out the activated charcoal filter.

2. Clean the appliance.

3. Clean the metal grease filters.

4. Secure the new activated charcoal filter using the holder on

the rear of the metal grease filter.

Regenerating the activated charcoal filter

Note: The activated charcoal filter can be regenerated up to

four times.

Note: Odours may develop when regenerating the activated

charcoal filter. Make sure that the room is well ventilated and

open a window if required.

Note: Regenerated air recirculation filters may be damaged if

they fall or are dropped. The damage is not always visible from

the outside. Dispose of and replace down any regenerated air

recirculation filters that fall or are dropped.

1. Remove the activated charcoal filter.

2. Heat the activated charcoal filter for 1 hour at 100 °C in the

oven (preheated) using air recirculation mode.

3. Allow the activated charcoal filter to cool down.

4. Fit the activated charcoal filter.

Cleaning the metal mesh grease filters

Notes

■ Do not use any aggressive, acidic or alkaline cleaning

agents.

■ When cleaning the metal mesh grease filters, also clean the

holder for the metal mesh grease filters in the appliance

using a damp cloth.

■ The metal mesh grease filters can be cleaned in the

dishwasher or by hand.

By hand:

Note: You can use a special grease solvent for stubborn dirt. It

can be ordered via the Online Shop.

■ Soak the metal mesh grease filters in a hot soapy solution.

■ Clean the filters with a brush and then rinse them thoroughly.

■ Leave the metal mesh grease filters to drain.

In the dishwasher:

Note: If the metal mesh grease filters are cleaned in the

dishwasher, slight discolouration may occur. This has no effect

on the function of the metal mesh grease filters.

■ Do not clean heavily soiled metal mesh grease filters together

with utensils.

■ Place the metal mesh grease filters loosely in the dishwasher.

The metal mesh grease filters must not be wedged in.

Installing the metal mesh grease filter

1. Insert metal grease filter.

2. Fold the metal grease filter up and click it into place.

3. Fold the filter cover upwards.

Note: Make sure that the filter cover closes properly.

Resetting the saturation displays

Once you have cleaned or replaced the relevant filters, reset

the saturation indicator to stop the symbols from flashing.

Make sure that the extractor hood and the lighting have been

switched off.

Press and hold the

Þ button for approximately 5 seconds until

all the buttons flash three times.

This resets the saturation indicators.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch DID106G20 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch DID106G20

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info