Operating the appliance en
9
Saturation display
If the grease filter or odour filter is saturated, the
corresponding LEDs will flash and a repeated signal
tone will sound after the appliance has been switched
off:
■ Grease filter: LED 1 flashes
■ Odour filter: LED 2 flashes
■ Grease filter and odour filter: LEDs 1 and 2 flash
The grease filters should now be cleaned or the odour
filter needs to be replaced. ~ "Cleaning and
maintenance" on page 13
The saturation indicators can be reset while they are
flashing. To do this, press the y button.
Settings for using the odour filter
1. When the appliance is switched off, press and hold
the # and y buttons for approx. 3 seconds.
The LED for the currently active filter setting lights up
on the appliance.
2. Press the @ button/A button until LED 2 for
circulating-air mode (filter cannot be regenerated)
lights up on the appliance.
3. Press the @ button/ A button until LED 3 for
circulating-air mode (filter can be regenerated) lights
up on the appliance.
4. Press the @ button/A button until LED 1 on the
appliance for the electronic controller is switched
back to operation without the air recirculation filter.
5. Press and hold the # and y buttons for
approx. 3 seconds to save the setting or wait for
around 10 seconds until the setting is saved
automatically.
A signal tone will sound.
Note: Press the # button to cancel the setting.
Lighting
The lighting can be switched on and off independently
of the fan.
Press the B button.
Setting the brightness
Press and hold the x or } button until the required
brightness is reached.
Note: Colour temperature settings are available in the
Home Connect app provided the appliance has this
function.
Button tone
Switching on or off
Note: Only button tones can be switched on and off.
Signal tones on the appliance cannot be switched off.
1. When the appliance is switched off, press and hold
the # and A buttons for approx. 3 seconds.
The LED in the currently selected setting lights up.
2. Press the @ or A button to change the setting.
The button tones are switched on if LED 1 lights up
on the appliance.
The button tones are switched off if LED 2 lights up
on the appliance.
3. Press and hold the # and A buttons for
approx. 3 seconds to save the setting or wait for
around 10 seconds until the setting is saved
automatically.
A signal tone will sound.
Note: Press the # button to cancel the setting.
