NOTE: The ON/OFF periods pre-programmed for
Hot Water pre-heat are shown in the
table opposite.
The factory installed settings can be used
without any further programming of the
receiver.
The date and time are pre-programmed
and should not require adjustment.
If you need to restore the factory pre-set
program times then:
Press the + and - buttons together, for at
least 3 seconds, to restore the default
program times.
NOTE: Two ON/OFF periods can be used
instead of three, by setting the second
ON/OFF periods to 12:00 as shown in
the default program table.
One ON/OFF period can be achieved by setting
the second and third ON/OFF periods to the
same time.
See RECEIVER PROGRAMMABLE SETTINGS
if changes are required to the clock time or pre-
programmed settings.
1st 1st 2nd 2nd 3rd 3rd
ON OFF ON OFF ON OFF
Hot Water:
MON to FRI
Time 06:30 08:30 12:00 12:00 16:30 22:30
SAT & SUN
Time 07:00 09:00 12:00 12:00 16:00 23:00
DT10RF RECEIVER
PRE-SET PROGRAMS
DT10RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 493a (02.2009)
OPERATING & INSTALLATION
INSTRUCTIONS
15
